P0521high severityPowertrain
Engine Oil Pressure Sensor/Switch Range/Performance
on 2013 Subaru Legacy 2.5L H4 · AWD
What this code means
Oil pressure sensor reading is out of expected range.
Symptoms
- Oil pressure gauge erratic
- Warning light flickering
Common causes
- Sensor fault
- Oil pressure fluctuating
- Worn oil pump
- Wrong viscosity oil
Diagnostic steps
- Test with mechanical gauge
- Check oil level and condition
- Test sensor
- Verify correct oil viscosity
Repair notes
Verify actual pressure. Replace sensor if pressure is good.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1