The 2013 Chrysler 200 is essentially a rebadged Sebring with carryover powertrains—the 2.4L Tigershark has catastrophic engine failure issues, while the 3.6L Pentastar is more robust but paired with transmission problems. Avoid the four-cylinder variants entirely.
2.4L Tigershark Engine Failure (Piston/Cylinder Wall Damage)
Common · high severityTypical onset: 60,000-100,000 mi
Symptoms: Excessive oil consumption (quart per 1,000 miles or worse), Blue smoke from exhaust on startup or acceleration, Cylinder misfire codes (P0300 series), Knocking or ticking noise from block, Complete engine seizure in worst cases
Fix: Piston skirt design and inadequate cylinder wall treatment cause scoring and ring land failure. Fix requires either short block replacement (18-24 hours labor) or full engine swap. Some extended warranty coverage existed but most are expired by now. Often more economical to replace vehicle than engine.
Estimated cost: $4,500-7,500
62TE Transmission Overheating and Failure
Common · high severityTypical onset: 80,000-130,000 mi
Symptoms: Transmission slipping between gears, especially 2-3 shift, Harsh or delayed engagement when cold, Limp mode with P0868 or P0841 codes (low line pressure), Burnt transmission fluid smell, Complete loss of forward gears
Fix: External transmission oil cooler lines corrode and leak, causing fluid loss and overheating. Solenoid pack and valve body also fail from heat damage. If caught early, cooler line replacement and fluid service runs 2-3 hours labor. Advanced cases need valve body (8-10 hours) or full rebuild (18-22 hours). Recall 14V-053 addressed some cooler issues but didn't cover all failure modes.
Estimated cost: $400-800 (cooler lines), $1,800-2,800 (valve body), $3,200-4,800 (rebuild)
TIPM (Totally Integrated Power Module) Failures
Occasional · high severitySymptoms: Intermittent no-start with no crank, Fuel pump not priming, Wipers, windows, or locks operating on their own, ABS and traction control lights with no stored codes, Gauges going haywire or going dead
Fix: The TIPM (fuse/relay box) has internal relay failures causing random electrical gremlins. Chrysler extended warranty to 10 years/150k on some VINs but many are past coverage. Requires TIPM replacement (1.5-2.5 hours) and sometimes reprogramming. Used modules are risky—get new or remanufactured with warranty.
Estimated cost: $800-1,400
Front Suspension Lower Control Arm Bushing Failure
Common · medium severityTypical onset: 70,000-110,000 mi
Symptoms: Clunking noise over bumps from front end, Steering wheel off-center after hitting pothole, Excessive tire wear on inside edge, Wandering or loose steering feel
Fix: OEM bushings are undersized and tear, allowing control arm movement. Requires both lower control arm assemblies replacement (2.5-3.5 hours labor for both sides) plus alignment. Aftermarket bushings fail just as quick—replace with full arms.
Estimated cost: $600-950
Water Pump Failure (3.6L Pentastar)
Occasional · medium severityTypical onset: 90,000-140,000 mi
Symptoms: Coolant leak from front of engine near timing cover, Squealing or grinding noise from serpentine belt area, Engine overheating, Coolant mixing with oil (rare but catastrophic if internal seal fails)
Fix: Pentastar water pump is internally mounted behind timing cover. Requires removal of timing cover and chains (6-8 hours labor). Check for coolant intrusion into oil before starting—if oil is milky, expect head gasket damage too. Preventive replacement not typically needed but if doing timing components anyway, replace pump while you're in there.
Estimated cost: $900-1,500
Fuel Pump and Fuel Filter Clogging
Occasional · medium severityTypical onset: 80,000-120,000 mi
Symptoms: Hard starting after sitting overnight, Stumbling or hesitation during acceleration, Stalling at idle or low speed, P0087 code (fuel rail pressure too low)
Fix: In-tank fuel filter sock clogs with sediment, starving fuel pump. Some also had pump motor failures. Requires fuel tank drop (2.5-3.5 hours). Replace pump assembly and clean tank while it's out. Recall 18V-355 covered some 2011-2012 models but 2013s typically not included.
Estimated cost: $600-1,000
Hard pass unless it's a deeply discounted 3.6L V6 with documented transmission services and you have a repair fund—the 2.4L is a ticking time bomb.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.