2016 INFINITI QX80

5.6L V8RWDAUTOMATICgas
5-Year Cost of Ownership
$10,524 maintenance + known platform issues
~$2,105/yr · 180¢/mile equivalent · $5,159 maintenance + $4,165 expected platform issues
Common Problems & Known Issues

The 2016 QX80 with the VK56VD 5.6L V8 is a generally robust luxury SUV, but a catastrophic engine defect—secondary timing chain guide failure—can destroy the motor between 60,000-120,000 miles, overshadowing all other concerns.

Secondary Timing Chain Guide Failure (Catastrophic Engine Damage)

Occasional · high severity
Typical onset: 60,000-120,000 mi
Symptoms: Cold-start rattle for 2-3 seconds that progressively worsens, Check engine light with cam/crank correlation codes (P0021, P0011), Sudden loss of power, metal shavings in oil, complete engine seizure if guides disintegrate
Fix: The plastic secondary chain guides (upper) wear and break apart, letting slack chains jump timing or fragments circulate through the engine destroying bearings, cylinder walls, and heads. Preventive fix is front timing cover removal, guide and chain replacement—12-16 hours labor. If it grenades the engine, you're looking at short block or complete rebuild with pistons, rings, bearings, and often head work. 40-60 hours labor for full rebuild.
Estimated cost: $3,500-6,000 preventive (chains/guides); $12,000-18,000 full rebuild after failure

Transmission Oil Cooler Line Corrosion and Leaks

Common · medium severity
Typical onset: 70,000-130,000 mi
Symptoms: Red ATF dripping near radiator or under front of vehicle, Transmission slipping or delayed shifts if fluid level drops significantly, Visible corrosion or green crusty buildup on steel cooler lines at crimp points
Fix: Steel cooler lines rust through where they crimp to rubber hoses, especially in salt states. Aftermarket stainless lines are available and recommended. Requires lifting vehicle, dropping crossmember in some cases for access. 3-5 hours labor including fluid refill and system purge.
Estimated cost: $600-1,200

Transmission Mount Deterioration

Common · low severity
Typical onset: 80,000-120,000 mi
Symptoms: Clunk or thud on hard acceleration or when shifting from Park to Drive, Vibration at idle that changes when shifting into gear, Visible cracking or oil saturation of rubber mount
Fix: The rear transmission mount softens and tears, allowing excessive drivetrain movement. Replacement is straightforward—support trans with jack, unbolt mount, swap. 1.5-2.5 hours labor. OEM mount is hydraulic-damped; aftermarket options exist but may increase NVH.
Estimated cost: $350-650

Fuel Pump and Sender Assembly Failure

Occasional · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: Intermittent stalling, especially when fuel level is below half-tank, Erratic fuel gauge readings or stuck at empty/full, No-start with crank but no fuel pressure (pump motor failure)
Fix: In-tank fuel pump module fails—either the pump motor itself or the level sender. Requires dropping the tank or removing rear seat and access panel (QX80 has panel under third-row seat area). 3-4 hours labor. Always replace strainer and check fuel filter in-line if applicable.
Estimated cost: $800-1,400

Radiator and Coolant Hose Leaks

Occasional · medium severity
Typical onset: 100,000-150,000 mi
Symptoms: Coolant smell or visible drips under front of vehicle, Slow coolant loss requiring top-ups between services, White residue or staining on radiator end tanks or hose connections
Fix: Plastic radiator end tanks crack at mounting tabs or hose necks; upper/lower hoses develop pinhole leaks at bends. Radiator replacement is 4-5 hours labor (requires condenser/front bumper support removal for access). Hoses alone are 1-2 hours.
Estimated cost: $600-1,000 hoses; $1,200-1,800 radiator

Valve Body and Solenoid Issues (7-Speed Transmission)

Occasional · medium severity
Typical onset: 80,000-130,000 mi
Symptoms: Harsh or delayed 2-3 or 3-4 shifts, Check engine light with transmission solenoid codes (P0745, P0750), Limp mode with transmission locked in 3rd or 4th gear
Fix: The RE7R01A transmission develops valve body wear and solenoid failures, often due to poor fluid maintenance. Fix requires pan drop, valve body removal, solenoid replacement, and sometimes full valve body replacement or reconditioning. 6-10 hours labor. Always replace pan gasket, filter, and do full fluid exchange.
Estimated cost: $1,800-3,500
Owner tips
  • Change engine oil every 5,000 miles maximum with quality 5W-30 to slow timing chain guide wear—extended intervals kill VK56 engines.
  • Inspect timing chain area for cold-start rattle religiously; if present, address immediately before catastrophic failure.
  • Transmission fluid should be changed every 60,000 miles (not lifetime despite what Nissan says)—use only Nissan Matic-S fluid.
  • Undercoat fuel and transmission cooler lines in rust-belt climates; aftermarket stainless lines are cheap insurance.
  • Keep coolant system maintained; overheating accelerates timing chain guide degradation.
Buy only with documented timing chain service or budget $5K-15K for engine work—the VK56 timing chain defect is a ticking time bomb that defines ownership risk.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
505 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →