The 2020 Murano uses Nissan's third-generation CVT (RE0F11A/JF016E), which continues to show the same fundamental weaknesses as earlier CVTs in the lineup. The VQ35DE is generally reliable, but when it fails, it fails catastrophically with bearing and piston problems that require complete rebuilds.
CVT Transmission Failure (Judder, Slipping, Overheating)
Common · high severityTypical onset: 60,000-120,000 mi
Symptoms: Shuddering or hesitation during acceleration, especially from stop, Whining or grinding noise from transmission, Transmission overheating warning light, Slipping between gear ratios or loss of power under load, Delayed engagement when shifting to Drive or Reverse
Fix: CVT replacement or rebuild required in most cases. Transmission oil cooler often fails first, causing fluid contamination and accelerating CVT death. Cooler replacement alone is 2-3 hours, but if CVT is damaged, you're looking at 8-12 hours for remanufactured unit installation with fluid, filter, and cooler. Extended warranty claim if under 84k mi (Nissan settlement coverage).
Estimated cost: $4,500-7,500
VQ35DE Catastrophic Engine Failure (Spun Bearings, Piston Damage)
Occasional · high severityTypical onset: 80,000-150,000 mi
Symptoms: Sudden loud knocking or ticking from engine bay, Metal shavings in oil during oil change, Loss of oil pressure (oil light illuminated), Rough running, misfires, or complete engine seizure, Excessive oil consumption leading up to failure (1 qt per 1,000 mi)
Fix: When the VQ35 goes, it typically takes bearings, pistons, and crank with it. You're not rebuilding heads—you need short block minimum, often complete engine replacement. 16-20 hours labor for engine R&R, plus machine work if attempting rebuild. Most shops recommend reman long block. Oil starvation from poor maintenance or failed oil pump is usual culprit.
Estimated cost: $6,000-9,500
Transmission Mount Failure
Common · medium severityTypical onset: 50,000-90,000 mi
Symptoms: Clunking when shifting from Park to Drive or Reverse, Excessive vibration at idle, especially with AC on, Transmission appears to 'drop' or shift position during hard acceleration, Visible cracking or separation of rubber mount material
Fix: The CVT's weight and vibration characteristics eat mounts faster than conventional automatics. Front transmission mount is the primary culprit. Replacement is straightforward: support transmission, unbolt old mount, install new. 1.5-2 hours labor. Replace both front and rear mounts at same time to avoid comeback.
Estimated cost: $350-600
Fuel Filter Clogging (Integrated Fuel Pump Module)
Occasional · medium severityTypical onset: 70,000-110,000 mi
Symptoms: Hard starting, especially after sitting overnight, Engine sputtering or hesitation under load, Loss of power at highway speeds, Check engine light with lean fuel codes (P0171/P0174), Fuel pump noise from tank area
Fix: Nissan uses an integrated fuel pump module with non-serviceable filter. When filter clogs (common with ethanol fuel), entire assembly needs replacement. Tank must be dropped: 3-4 hours labor. Some techs cut access panel through rear seat area to avoid full tank drop (2 hours), but warranty concerns apply.
Estimated cost: $800-1,400
Rear Suspension Knuckle/Bearing Assembly Failure
Occasional · medium severityTypical onset: 60,000-100,000 mi
Symptoms: Humming or growling noise from rear, increases with speed, Clunking over bumps from rear suspension, Uneven rear tire wear, Play in rear wheel when jacked up (grab at 12 and 6 o'clock), ABS/traction control warning lights (wheel speed sensor affected)
Fix: Rear wheel bearing integrated into hub/knuckle assembly. Unlike fronts, rears cannot be pressed out—entire knuckle assembly replacement required. NHTSA recall addressed some spindle failures, but bearing wear is separate issue. 2.5-3 hours per side: disconnect trailing arms, control arms, brake, ABS sensor, press out axle, install new knuckle. Do both sides if one fails past 80k.
Estimated cost: $700-1,100
Steering Rack Internal Seal Leakage
Occasional · medium severityTypical onset: 70,000-120,000 mi
Symptoms: Power steering fluid leak visible on inner tie rod boots or rack bellows, Groaning or whining when turning at low speed, Stiff steering, especially when cold, Power steering fluid level drops repeatedly, Steering pulls to one side (if leak is uneven)
Fix: Internal rack seals fail, leaking fluid into bellows boots. Rack rebuild not practical—replacement is standard. 4-5 hours labor: subframe must be partially lowered for access, disconnect tie rods, pressure/return lines, steering shaft coupler. Alignment required after. NHTSA recall covered linkage separations, not seal leaks.
Estimated cost: $1,200-1,800
Hard pass unless you're getting it under $15k with full CVT service records and pre-purchase compression test—too many expensive grenades on a timer.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.