1979 PONTIAC BONNEVILLE

Typical onset: 90,000-140,000 mi

Symptoms: Slipping on 1-2 or 2-3 shifts, especially under load, Burnt transmission fluid smell or dark brown/black fluid, Delayed engagement into gear from Park or Neutral, Loss of reverse or second gear

Fix: Full rebuild with updated clutch packs, bands, and seals. Expect 12-16 hours labor. The TH350 behind smaller V8s is more prone to failure than the TH400 behind 403s. Always replace the cooler lines and flush the external cooler during rebuild.

Estimated cost: $1,800-2,800

Symptoms: Hard starting when cold or hot, Stumble or bog on acceleration, Black smoke from exhaust indicating rich condition, Flooding or fuel smell in engine bay, Poor fuel economy below 10 mpg

Fix: Rochester Quadrajet carbs need full rebuild kits every 40-50k miles or when sitting unused. Accelerator pump, power piston springs, and choke pull-off are common failures. Plan 3-5 hours for proper disassembly, cleaning, and recalibration. Many shops now recommend aftermarket replacement due to parts scarcity.

Estimated cost: $400-750

Typical onset: 80,000-120,000 mi

Symptoms: Oil puddle under rear of engine after overnight parking, Oil coating on bellhousing and transmission case, Visible seepage around oil pan rails, Low oil level requiring frequent top-offs (1 qt per 500-800 miles)

Fix: Rope-style rear main seal requires transmission removal. Oil pan gaskets leak at corners due to cork deterioration. Rear main is 8-10 hours with transmission out; oil pan is 3-4 hours. Smart move is doing both simultaneously if transmission is already coming out for other work.

Estimated cost: $800-1,400

Typical onset: 70,000-110,000 mi

Symptoms: Coolant loss with no visible external leaks, White smoke from exhaust on cold start, Rough idle or misfire as coolant enters cylinders, Milky residue on oil cap or dipstick in severe cases

Fix: The 301, 305, and 350 V8s used composite intake gaskets that deteriorate and allow coolant into the valley or cylinders. Requires intake removal, deck cleaning, and installation of modern Fel-Pro gaskets. 4-6 hours labor. Check for warped intake surfaces.

Estimated cost: $500-900

Typical onset: 100,000-150,000 mi

Symptoms: Rattling noise from front of engine on cold start that quiets after warmup, Loss of power and poor performance, Check timing and find it's retarded 8-12 degrees from spec, Metal shavings in oil or timing cover area

Fix: Nylon-coated timing gears from this era deteriorate and cause 3-6 inches of chain slack. Timing set replacement requires removing harmonic balancer, timing cover, water pump, and radiator. 6-8 hours labor. Replace with steel double-roller set, not OEM-style nylon.

Estimated cost: $600-1,100

Symptoms: Transmission fluid leaking at radiator connections, Fluid spraying onto exhaust manifolds creating smoke and smell, Sudden total fluid loss and transmission failure, Pink milky fluid in radiator indicating internal cooler rupture

Fix: Steel cooler lines rust through at mounting clips or where they pass over the crossmember. External leaks are 1-2 hours to replace lines. Internal radiator cooler failure mixes coolant and ATF — requires radiator replacement, full transmission rebuild, and cooling system flush. This is a tow-home failure.

Estimated cost: $150-300 for lines only, $2,500-3,500 if cooler contaminates transmission

Symptoms: Surface rust perforation visible on frame rails behind front crossmember, Control arm mounts showing structural rust or cracking, Rear leaf spring shackles rusted and seized, Poor handling or alignment issues that can't be corrected

Fix: B-bodies from the Midwest and Northeast show frame rot in the front subframe mounts and torque boxes. Repair requires sectioning and welding new steel — not a bolt-on job. Control arm bushing replacement becomes destructive removal due to rust fusion. Walk away from rusty frames; repairs exceed vehicle value.

Estimated cost: $2,000-5,000+ depending on extent