2015 SUBARU FORESTER

2.5L H4AWDCVTgas
5-Year Cost of Ownership
$12,676 maintenance + known platform issues
~$2,535/yr · 210¢/mile equivalent · $5,159 maintenance + $6,682 expected platform issues
Compare this engine
vs
2.5L H4 Turbo
Common Problems & Known Issues

The 2015 Forester with the naturally-aspirated 2.5L FB25 is generally reliable, but the platform suffers from head gasket seepage issues inherited from earlier EJ engines (though less catastrophic), CVT cooler line failures, and oil consumption problems that can grenade motors if ignored.

CVT Transmission Oil Cooler Line Failure

Common · high severity
Typical onset: 60,000-110,000 mi
Symptoms: Transmission fluid dripping or pooling under vehicle, Burnt smell from overheating CVT fluid, Transmission overheating warning light, Sudden loss of drive with complete fluid loss
Fix: Replace oil cooler lines and seals; often requires dropping the subframe for access. 3-5 hours labor depending on whether subframe removal is needed. Refill CVT fluid and check for internal damage.
Estimated cost: $800-1,500

Excessive Oil Consumption (FB25 Engine)

Common · high severity
Typical onset: 50,000-90,000 mi
Symptoms: Low oil warning light between changes, Burning 1+ quart per 1,000 miles, Blue smoke on cold starts or acceleration, Fouled spark plugs
Fix: Root cause is piston ring design and cylinder glazing. Subaru extended warranty covered some cases. Fix requires full short block replacement or engine rebuild with updated pistons/rings. 18-24 hours labor for short block swap.
Estimated cost: $4,500-7,000

Head Gasket Seepage

Occasional · medium severity
Typical onset: 80,000-140,000 mi
Symptoms: External coolant weeping at head/block mating surface, Slight coolant smell after driving, Minor drops or staining on driveway, Slow coolant loss without visible leaks elsewhere
Fix: Not the catastrophic internal failures of older EJ engines, but external seepage is common. Requires head removal, resurfacing, new gaskets, timing components. 12-16 hours labor for both sides.
Estimated cost: $2,500-3,800

Brake Light Switch Failure

Common · medium severity
Symptoms: Brake lights stay on constantly, Brake lights don't illuminate when pedal pressed, Cruise control won't engage or disengage, Push-button start may not work, Shift interlock problems (can't shift out of park)
Fix: Simple switch replacement above brake pedal. Subject to recall but many vehicles fall outside VIN range. 0.5 hours labor.
Estimated cost: $150-250

Rear Wheel Bearing Noise

Occasional · medium severity
Typical onset: 70,000-120,000 mi
Symptoms: Humming or growling from rear that increases with speed, Noise changes with cornering, May feel vibration through seat
Fix: Replace rear hub/bearing assembly. AWD vehicles eat bearings faster with mismatched tires or deferred maintenance. 1.5-2 hours per side.
Estimated cost: $350-550 per side

Turbo Wastegate Rattle (2.0XT Models Only)

Occasional · low severity
Typical onset: 40,000-80,000 mi
Symptoms: Rattling noise from engine bay at idle or light throttle, Noise disappears under boost, No performance loss initially
Fix: Wastegate actuator arm wears and creates play. Can lead to boost control issues if ignored. Turbo replacement or actuator rebuild required. 6-8 hours labor for turbo R&R.
Estimated cost: $1,800-2,800
Owner tips
  • Check oil level every 1,000 miles religiously — the FB25 oil consumption issue can destroy an engine in under 500 miles if oil runs critically low
  • Replace CVT fluid every 30,000-40,000 miles regardless of 'lifetime fill' claims; saves transmissions
  • Inspect CVT cooler lines annually for seepage or corrosion, especially in salt states
  • Keep all four tires within 2/32" tread depth to prevent AWD system and bearing damage
  • Address head gasket seepage early before it becomes an internal failure
Solid daily driver if oil consumption hasn't started and CVT has been maintained, but budget $1,500-2,000 for deferred issues on higher-mileage examples — avoid any burning oil.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
505 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →