P1296moderate severityPowertrain
Cooling System Malfunction
on 2011 Audi Q7 3.0L Supercharged V6 · AWD
What this code means
The ECU detected that the engine cooling system is not operating within expected parameters. The coolant temperature is not reaching or maintaining the expected operating range within the allotted time.
Symptoms
- Check Engine Light
- Engine running cold
- Poor heater output
- Reduced fuel economy
- Higher emissions
Common causes
- Thermostat stuck open
- Coolant temperature sensor fault
- Low coolant level
- Cooling fan running constantly
- Coolant leak causing slow warm-up
Diagnostic steps
- Check coolant level and condition
- Monitor coolant temperature rise during warm-up with scan tool
- Test thermostat operation
- Test coolant temperature sensor
- Check for coolant leaks
Repair notes
Replace the thermostat if the engine is not reaching operating temperature.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1