P2128critical severityPowertrain
Throttle/Pedal Position Sensor/Switch E Circuit High
on 2013 Ford Fusion 2.5L I4 · FWD
What this code means
High voltage from accelerator pedal position sensor E.
Symptoms
- Limp mode
- Check engine light
- Possible unintended throttle input
Common causes
- Open ground
- Short to voltage in harness
- Failed sensor
Diagnostic steps
- Measure sensor E voltage
- Check ground circuit
- Inspect wiring
Repair notes
Replace accelerator pedal assembly or repair wiring.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1