P2401moderate severityPowertrain
EVAP Leak Detection Pump Control Circuit Low
on 2013 Ford Fusion 2.5L I4 · FWD
What this code means
Low voltage on the EVAP leak detection pump control circuit.
Symptoms
- Check engine light
- Failed EVAP test
Common causes
- Short to ground
- Damaged harness
- Pump motor failure
Diagnostic steps
- Measure circuit voltage
- Check for shorts to ground
- Test pump
Repair notes
Repair short or replace pump.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1