C0222moderate severityChassis
EPS Control Module Voltage High
on 2009 Subaru Outback 3.0L H6 · AWD
What this code means
The EPS module supply voltage exceeds the maximum safe operating threshold.
Symptoms
- EPS warning light
- EPS assist may shut down
- Warning for electrical system
Common causes
- Alternator overcharging
- Voltage regulator failure
- Jump-starting voltage spike
- Aftermarket charger connected while running
Diagnostic steps
- Test charging system voltage (should be 13.5-14.7V)
- Check alternator voltage regulator
- Inspect for aftermarket electrical accessories
- Monitor system voltage under various loads
Repair notes
Repair overcharging alternator. Replace voltage regulator.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0026
RF Wheel Speed Sensor Circuit Intermittent
C0027
LR Wheel Speed Sensor Circuit Intermittent
C0028
RR Wheel Speed Sensor Circuit Intermittent
C0035
Left Front Wheel Speed Sensor Circuit
C0036
Left Front Wheel Speed Signal Erratic