The 2012 Cayman (987.2 generation, NOT 718—that designation started in 2017) with the 2.7L M97 flat-six is generally solid, but the M97 engine family has a well-documented weakness: intermediate shaft (IMS) bearing failure and bore scoring that can destroy the engine without warning.
IMS Bearing Failure Leading to Catastrophic Engine Damage
Occasional · high severityTypical onset: 60,000-100,000 mi
Symptoms: metal shavings in oil, rattling noise from engine on cold start, sudden loss of oil pressure, check engine light with cam/crank correlation codes, catastrophic engine seizure with no warning
Fix: The intermediate shaft bearing can fail, dropping metal debris into the engine and destroying internals. Prevention requires IMS bearing retrofit (8-12 hours labor, engine-out preferred). Once failed, you're looking at full engine rebuild or replacement—short block, pistons, bearings, machine work (60-80 hours labor). Many owners do IMS upgrade proactively during clutch jobs.
Estimated cost: $8,000-15,000
Cylinder Bore Scoring and Piston/Ring Failure
Occasional · high severityTypical onset: 80,000-120,000 mi
Symptoms: excessive oil consumption (1 qt per 1,000 mi or more), blue smoke on cold start or deceleration, loss of compression, rough idle, metallic knocking under load
Fix: M97 engines with Lokasil cylinder liners can develop scoring from insufficient lubrication during cold starts or break-in abuse. Requires bore inspection via borescope, then full tear-down: pistons, rings, machine work or cylinder sleeving, reassembly (50-70 hours). Some shops recommend Nikasil re-plating or aftermarket sleeves. Often combined with IMS bearing replacement while engine is apart.
Estimated cost: $12,000-18,000
Transmission Oil Cooler Line Leaks
Common · medium severityTypical onset: 70,000-110,000 mi
Symptoms: transmission fluid spots under car, low fluid warning on PDK models, burnt transmission smell, hard shifts or slipping on manual transmissions after fluid loss
Fix: Metal hard lines from transmission to cooler develop corrosion and crack at bends or connections. Replace both cooler lines and inspect cooler itself (2-4 hours labor). Left unaddressed, low fluid destroys the transmission.
Estimated cost: $600-1,200
Transmission Mount Failure (Manual and PDK)
Common · medium severityTypical onset: 60,000-100,000 mi
Symptoms: excessive drivetrain clunk on shifts or throttle tip-in, vibration through cabin at idle, shifter slop or vague engagement, visible tearing or fluid leakage from mount
Fix: Rubber mounts fail from age and heat. Requires lift, transmission support, and R&R of mount (2-3 hours labor). Both front and rear mounts should be inspected; often replaced as a pair.
Estimated cost: $500-900
Rear Main Seal Oil Leak
Occasional · medium severityTypical onset: 80,000-120,000 mi
Symptoms: oil pooling at transmission bellhousing, oil spots under rear of car, clutch contamination leading to slip (manual trans), oil smell from engine bay
Fix: Rear main seal hardens and leaks over time. Requires transmission removal (8-12 hours labor for manual, 10-14 for PDK). Often done during clutch replacement to save labor overlap. Small leaks can be monitored; major leaks destroy clutches.
Estimated cost: $1,800-3,200
Coolant Expansion Tank and Hose Cracking
Common · low severityTypical onset: 60,000-90,000 mi
Symptoms: coolant smell from engine bay, low coolant warning, visible coolant residue on tank or hoses, overheating in extreme cases
Fix: Plastic expansion tank and rubber coolant hoses become brittle with heat cycling. Replace tank, cap, and suspect hoses proactively (1.5-2.5 hours labor). Inexpensive and prevents being stranded.
Estimated cost: $400-700
A fantastic driving experience if the engine is healthy, but the M97 motor is a ticking time bomb—buy only with proof of IMS bearing upgrade and clean borescope, or budget $15k for catastrophic engine failure.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.