Mass Airflow Sensor
2022 Toyota Camry · 2.5L I4
Sensor Type
thermistor
Waveform Type
dc-variable
Location
Intake air duct between air filter housing and throttle body, approximately 6 inches downstream of air filter
Pins
4-pin connector
Timebase
500ms/div
Voltage Scale
1V/div
Trigger
Not applicable - DC signal
Wiring
12V power - pink or white, signal output - yellow or light green, ground - black, IAT sensor - typically orange or blue
Expected Voltage Range
At Idle
0.8V to 1.5V
At Higher RPM
3V to 4.8V
Expected Pattern
Smooth DC voltage that increases proportionally with airflow, idle approximately 1.0-1.3V, gradual rise to 3.5-4.5V at WOT snap throttle
Known-Good Waveform
Smooth, stable DC voltage at idle between 1.0-1.3V with minimal fluctuation (less than 0.05V ripple). During snap throttle test, voltage should rise smoothly and proportionally to approximately 3.5-4.5V, then decay smoothly back to idle without steps, spikes, or dropouts. Response time should be immediate with no lag or hesitation.
Common Failure Patterns
Voltage stuck at 0.2-0.5V or reading above 4.8V regardless of airflow
Cause: Failed MAF sensing element, contaminated hot wire, or open/short in signal circuit
Voltage shows steps, irregular jumps, or erratic fluctuations during steady idle or acceleration
Cause: Contaminated sensing element from oil vapor or dirt, damaged hot wire element
Diagnostic Tips
Toyota uses hot-wire MAF sensors prone to contamination from oiled aftermarket air filters. Never use MAF cleaner excessively - light cleaning only. Compare MAF voltage to calculated airflow (scan tool g/s reading); idle should be 2.5-4.0 g/s. Verify no intake leaks downstream which cause lean condition without MAF detection.
Related Diagnostic Trouble Codes
P0100P0101P0102P0103P0104
Always confirm waveform data with your vehicle's OEM service manual before diagnosing.
Free, no signup. View all waveforms for this vehicle