🚨 2025 Hyundai Santa Fe Plug-in Hybrid: Emergency Neutral
The 2025 Santa Fe PHEV uses an electronic push-button shift system with P, R, N, D buttons arranged vertically on the center console.
✓ Expert-verified by Chris Hackleman & Jeff Moore — master technicians, 20+ years each.
⚠️ Chock the wheels first — neutral means the car can roll. Set the parking brake while you work, never stand downhill of the vehicle, and try a 12-volt jump before any override: power fixes most stuck-in-park problems instantly.
The procedure
- Ensure the vehicle is on a level surface and apply the parking brake firmly.
- Turn the ignition to ON (READY mode not required for shift unlock).
- Locate the shift lock release cover—a small rectangular cap in the lower center console area near or below the shift buttons.
- Use a flathead screwdriver or similar tool to carefully pry off the shift lock release cover.
- Insert the screwdriver or a key into the shift lock release slot and press down while simultaneously pressing the N (Neutral) button.
- The transmission should now engage Neutral; verify by attempting to roll the vehicle slightly (with brake released in a safe environment).
- If towing, leave the shift lock release tool in place or keep Neutral engaged; consult the owner's manual for tow mode activation if extended towing is needed.
Shift-lock override location
Small rectangular cover in the lower center console area near or below the electronic shift buttons; exact position may vary slightly but typically forward or below the button cluster.
With zero electrical power
With zero 12V power, you cannot activate the ignition or electronic shift system. The shift lock override requires at least accessory power (ignition ON). Jump-start the 12V battery or connect an external power source to the 12V terminals under the hood to restore accessory power, then follow the override procedure. The high-voltage hybrid battery does not help here—only the 12V system matters for shifter electronics.
⚡ EV / hybrid warning
PHEV WARNING: This vehicle must be flatbed towed if the high-voltage system is faulted or if towing more than 1-2 miles. Do NOT tow with drive wheels on the ground for extended distances. If the 12V battery is dead but the HV system is functional, you may be able to use 'tow mode' after jump-starting the 12V—consult the owner's manual. For emergency neutral access with no power, jump the 12V battery first.