P2764high severityPowertrain
Torque Converter Clutch Pressure Control Solenoid Stuck Off
on 2000 Audi A4 2.8L V6 · AWD
What this code means
The TCC pressure control solenoid is stuck in the off position.
Symptoms
- No torque converter lockup
- Higher RPM at highway speed
- Poor fuel economy
- Overheating transmission
Common causes
- Failed solenoid
- Contaminated fluid blocking valve
- Valve body stuck
Diagnostic steps
- Command TCC operation with scan tool
- Check for fluid contamination
- Pressure test
Repair notes
Replace solenoid. Check for debris in valve body.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1