P2116high severityPowertrain
Pedal Position Sensor/Switch E Minimum Stop Performance
on 2003 Audi A6 3.0L V6 · AWD
What this code means
The accelerator pedal position sensor E is not reading its expected minimum stop value. This points to a fault in the pedal sensor or its signal circuit.
Symptoms
- Check engine light on
- Poor throttle response
- Limp mode or reduced power
Common causes
- Faulty accelerator pedal position sensor
- Wiring or connector corrosion
- Debris under pedal assembly
- Failed PCM reference to pedal sensor
Diagnostic steps
- Scan and view pedal position live data
- Inspect pedal sensor wiring and connector
- Check for obstructions at pedal
- Replace pedal position sensor if out of range
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1