P3600low severityPowertrain
Auto Start-Stop System Malfunction
on 2011 Audi A6 3.0L Supercharged V6 · AWD
What this code means
The automatic engine start-stop system has been disabled due to a detected fault. The system shuts off the engine at stops to save fuel.
Symptoms
- Start-stop indicator shows fault
- Engine does not shut off at stops
- Start-stop disabled message on dash
- Slightly higher fuel consumption
- Start-stop light flashing
Common causes
- Weak 12V battery
- Battery sensor failure
- Starter motor wear
- Engine temperature out of range
- Brake vacuum insufficient
Diagnostic steps
- Read start-stop system status and inhibit reasons
- Test 12V battery state of health
- Check IBS (intelligent battery sensor)
- Monitor brake vacuum level
- Check starter motor engagement count
Repair notes
Replace 12V battery if state of health is low. Register new battery with BMS. Replace IBS if faulty.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1