P3010high severityPowertrain
Camshaft Profile Actuator A Stuck Bank 1
on 2019 Audi A6 3.0L V6 TFSI · AWD
What this code means
The camshaft profile switching actuator for Bank 1, intake side, is mechanically stuck in one position. Multi-profile camshafts switch between low and high RPM cam lobes.
Symptoms
- Check Engine Light
- Loss of high-RPM power
- Rough idle if stuck on high cam
- VTEC/VANOS-like system not engaging
- Engine sounds different at high RPM
Common causes
- Oil sludge blocking actuator passages
- Actuator solenoid failure
- Low oil pressure
- Worn actuator pins or springs
- Incorrect oil viscosity
Diagnostic steps
- Check engine oil level and condition
- Monitor camshaft profile PID on scan tool
- Command profile switch and verify response
- Test oil pressure at actuator feed
- Inspect actuator screen for debris
Repair notes
Flush engine oil system. Replace cam profile actuator solenoid. If pins are worn, camshaft replacement may be needed.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1