P3061moderate severityPowertrain
Shift Quality - Harsh Upshift Detected
on 2019 Audi A6 3.0L V6 TFSI · AWD
What this code means
The TCM detected shift quality parameters outside acceptable range during upshifts. Shift flare or bind-up is occurring.
Symptoms
- Check Engine Light
- Harsh 1-2 or 2-3 upshift
- Vehicle jerks during upshift
- Passengers feel impact during shifts
- Delayed then sudden engagement
- Driveline clunk on shifts
Common causes
- Worn shift solenoid
- Incorrect line pressure
- Accumulator piston wear
- Valve body bore wear
- Transmission fluid degradation
Diagnostic steps
- Monitor shift time and quality PIDs
- Check line pressure at each gear
- Inspect shift solenoids electrically
- Review TCM shift adaptation values
- Perform fluid and filter service
Repair notes
Replace shift solenoids or valve body. Transmission fluid service may help in early stages. Reset shift adaptations after repair.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1