P0380moderate severityPowertrain
Glow Plug/Heater Circuit A
on 2010 Audi Q7 3.0L TDI V6 · AWD
What this code means
Malfunction in the glow plug heating circuit. Glow plugs are used in diesel engines to preheat the combustion chamber for cold starting.
Symptoms
- Check Engine Light
- Hard cold starting
- White smoke on cold start
- Extended cranking
- Rough idle when cold
Common causes
- Faulty glow plug(s)
- Glow plug relay failure
- Glow plug module failure
- Wiring damage
- Blown fuse
Diagnostic steps
- Test individual glow plug resistance (typically 0.5-2 ohms)
- Check glow plug relay
- Test glow plug module
- Check fuse
- Inspect wiring
Repair notes
Test each glow plug individually. Replace any with open circuit or high resistance. Check relay/module.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1