Back to 2010 Audi Q7
Help
2010 AUDI Q7
3.0L TDI V6•AWD•AUTOMATIC•diesel•turbo
3 active safety recalls on this vehicle — view recalls
Founding sponsor spot is openYour name on every procedure for this vehicle, permanently.Sponsor — $99 →
Repairs0Labor546Torque4686Fluid9DTC767Battery1Maintenance0Recalls3
P3892moderate severityPowertrain

Exhaust Gas Temperature Sensor Rationality - Post Aftertreatment

on 2010 Audi Q7 3.0L TDI V6 · AWD

What this code means

The exhaust gas temperature sensor after the aftertreatment system shows readings that do not correlate with upstream sensors and engine operating conditions.

Symptoms

  • Check Engine Light
  • Incorrect aftertreatment temperature monitoring
  • DPF regen timing affected
  • False overtemperature warnings
  • Aftertreatment protection mode may activate incorrectly

Common causes

  • EGT sensor drift
  • Sensor contaminated with soot
  • Wiring resistance increased
  • Sensor response time degraded
  • Exhaust leak affecting sensor reading

Diagnostic steps

  1. Compare pre and post aftertreatment EGT readings
  2. Test EGT sensor response time
  3. Measure sensor resistance at known temperature
  4. Inspect sensor for soot contamination
  5. Check for exhaust leaks near sensor

Repair notes

Replace exhaust gas temperature sensor. Clean sensor bung of soot buildup. Verify temperature readings correlate after replacement.

Other Powertrain codes on this vehicle

🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years and Jeff Moore · Master Lexus & Toyota Mechanic · 20+ years. Spot an error? Use the Help link above — a human reads every report.
Stuck on this repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Share:XRedditFBWhatsAppThreadsEmail
⚠ STILL BEHIND THE PAYWALL
The 2010 Audi Q7 repair data is incomplete because no one has sponsored it yet. For $99, we generate the full step-by-step procedures, then fact-check them with a second AI pass and your expert review. Your name on every procedure, permanently.
The same data would cost $169/mo from Mitchell1 or $30/year from ALLDATAdiy — and you'd be renting access, not freeing it. Sponsor once, free forever.
Sponsor the Audi Q7 — $99 →
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included.
Try ShopBase →