P0103moderate severityPowertrain
Mass Air Flow (MAF) Circuit High Input
on 2011 Audi Q7 3.0L Supercharged V6 · AWD
What this code means
The MAF sensor signal voltage is higher than the maximum expected value.
Symptoms
- Check Engine Light
- Lean fuel condition
- Poor acceleration
- Engine surge
Common causes
- Faulty MAF sensor
- Short to voltage in signal wire
- Water damage to sensor
Diagnostic steps
- Check MAF sensor connector
- Test signal voltage
- Inspect wiring for shorts to power
- Test sensor output
Repair notes
Replace MAF sensor or repair wiring.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1