P0808moderate severityPowertrain
Clutch Position Sensor Circuit Low
on 2011 Audi Q7 3.0L Supercharged V6 · AWD
What this code means
The clutch position sensor circuit is reading a voltage below the normal range. This usually points to a short to ground or open circuit.
Symptoms
- Shift quality problems
- Warning light on
- Clutch engagement issues
Common causes
- Short to ground in wiring
- Faulty clutch position sensor
- Corroded or loose connector
- Open circuit in signal wire
Diagnostic steps
- Retrieve and record fault codes
- Inspect wiring for shorts to ground
- Check sensor supply and signal voltage
- Replace sensor or repair wiring as needed
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1