P0801moderate severityPowertrain
Reverse Inhibit Control Circuit
on 2014 Audi Q7 3.0L Supercharged V6 · AWD
What this code means
A fault has been detected in the reverse inhibit control circuit, which prevents accidental engagement of reverse gear. This can affect the ability to select or lock out reverse.
Symptoms
- Difficulty engaging reverse
- Check engine light on
- Reverse lockout not functioning
Common causes
- Faulty reverse inhibit solenoid
- Open or short in control circuit wiring
- Damaged connector at transmission
- Faulty transmission control module
Diagnostic steps
- Scan and record freeze frame data
- Inspect reverse inhibit circuit wiring and connectors
- Test solenoid resistance against spec
- Check TCM output command and power supply
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1