P3015moderate severityPowertrain
Intake Valve Control Solenoid Circuit Intermittent Bank 1
on 2008 Audi R8 4.2L V8 · AWD
What this code means
The intake valve control solenoid on Bank 1 has an intermittent electrical fault. Continuous VVT systems use this solenoid to control cam phasing oil flow.
Symptoms
- Check Engine Light comes and goes
- Intermittent rough idle
- Sporadic power loss
- Variable valve noise
- Inconsistent fuel economy
Common causes
- Loose solenoid connector
- Wiring chafing against engine
- Solenoid internal intermittent failure
- Thermal expansion causing contact loss
- Corroded pins
Diagnostic steps
- Monitor VVT solenoid command vs cam position
- Wiggle test on solenoid connector
- Inspect wiring harness routing
- Check connector pin tension
- Test solenoid at operating temperature
Repair notes
Repair connector or replace VVT solenoid. Re-route wiring away from heat sources.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1