P3066moderate severityPowertrain
Transmission Range Sensor Rationality Error
on 2008 Audi R8 4.2L V8 · AWD
What this code means
The transmission range sensor (TRS) reading does not agree with other inputs such as gear state solenoids and output shaft speed.
Symptoms
- Check Engine Light
- Incorrect gear displayed on dash
- Transmission may not shift out of park
- Backup lights on in drive
- Wrong gear engagement
- Intermittent no-start in Park
Common causes
- TRS misadjusted
- TRS internal failure
- Shift linkage loose or worn
- TRS connector corroded
- TRS wiring short
Diagnostic steps
- Compare TRS signal to actual gear selector position
- Inspect shift linkage adjustment
- Test TRS voltage in each gear position
- Check TRS connector
- Monitor TRS signal for dropouts
Repair notes
Adjust or replace transmission range sensor. Check and adjust shift linkage. Verify correct gear display in all selector positions.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1