P3063high severityPowertrain
Torque Converter Clutch Capacity Low
on 2009 Audi R8 5.2L V10 (Gen 1, 525hp) · AWD
What this code means
The torque converter clutch is not transmitting the expected amount of torque. Slip is detected beyond the normal engagement tolerance.
Symptoms
- Check Engine Light
- TCC shudder at highway speed
- Slight RPM fluctuation at cruise
- Reduced fuel economy at highway
- Torque converter area overheating
- Vibration at steady throttle
Common causes
- Worn torque converter clutch lining
- Degraded transmission fluid
- TCC apply solenoid weak
- Internal seal leak
- TCC damper spring failure
Diagnostic steps
- Monitor TCC slip PID at steady cruise
- Check transmission fluid condition
- Test TCC apply pressure
- Inspect TCC solenoid operation
- Perform stall speed test
Repair notes
Replace torque converter. Flush transmission fluid. Some vehicles respond to fluid replacement alone.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1