Back to 2009 Audi R8
Help
2009 AUDI R8
5.2L V10 (Gen 1, 525hp)•AWD•AUTOMATIC•gas•BUJ
Founding sponsor spot is openYour name on every procedure for this vehicle, permanently.Sponsor — $99 →
Repairs0Labor492Torque4246Fluid9DTC1087Battery1Maintenance0Recalls0
P3624high severityPowertrain

Cylinder Deactivation System Oil Pressure Low

on 2009 Audi R8 5.2L V10 (Gen 1, 525hp) · AWD

What this code means

The oil pressure dedicated to the cylinder deactivation system is below the minimum threshold for reliable lifter switching.

Symptoms

  • Check Engine Light
  • Cylinder deactivation disabled
  • Engine noise during attempted deactivation
  • Lifter tick on deactivation command
  • Oil pressure warning at idle

Common causes

  • Low engine oil level
  • Oil pump wear reducing pressure
  • Wrong oil viscosity installed
  • VLOM assembly internal leak
  • Clogged oil filter restricting flow

Diagnostic steps

  1. Check engine oil level and condition
  2. Measure oil pressure at deactivation gallery
  3. Verify correct oil viscosity
  4. Test VLOM assembly seal integrity
  5. Inspect oil filter for restriction

Repair notes

Top off or change engine oil with correct AFM-compatible specification. Replace oil pump if pressure is low at all speeds. Replace VLOM if internal leak found.

🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.

Other Powertrain codes on this vehicle

🔌 Need this data in your app? It's all in the free API →
🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years and Jeff Moore · Master Lexus & Toyota Mechanic · 20+ years. Spot an error? Use the Help link above — a human reads every report.
Stuck on this repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Share:XRedditFBWhatsAppThreadsEmail
⚠ STILL BEHIND THE PAYWALL
The 2009 Audi R8 repair data is incomplete because no one has sponsored it yet. For $99, we generate the full step-by-step procedures, then fact-check them with a second AI pass and your expert review. Your name on every procedure, permanently.
The same data would cost $169/mo from Mitchell1 or $30/year from ALLDATAdiy — and you'd be renting access, not freeing it. Sponsor once, free forever.
Sponsor the Audi R8 — $99 →
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included.
Try ShopBase →