P3003moderate severityPowertrain
Turbo/Supercharger Boost Pressure Sensor Circuit Intermittent
on 2015 Audi R8 5.2L V10 (Gen 1, 525hp) · AWD
What this code means
The boost pressure sensor signal is intermittent, causing erratic boost control. The PCM detects signal dropouts or sudden voltage changes.
Symptoms
- Check Engine Light intermittent
- Fluctuating boost gauge
- Inconsistent power delivery
- Occasional limp mode
- Surging under load
Common causes
- Loose boost pressure sensor connector
- Damaged sensor wiring
- Faulty boost pressure sensor
- Vibration-related intermittent contact
- Corroded sensor pins
Diagnostic steps
- Monitor boost pressure PID for signal dropouts
- Wiggle test on sensor connector while monitoring data
- Inspect sensor connector pins for corrosion
- Check wiring harness routing near heat sources
- Swap sensor with known good unit if available
Repair notes
Replace boost pressure sensor or repair intermittent wiring connection.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1