P0011moderate severityPowertrain
Intake Camshaft Position Timing Over-Advanced Bank 1
on 2011 Audi TT 2.0L Turbo I4 · AWD
What this code means
The intake camshaft timing for Bank 1 is more advanced than the PCM commanded. This is often caused by a stuck VVT solenoid or sludge in the oil passages.
Symptoms
- Check Engine Light
- Rough idle
- Poor fuel economy
- Engine stalling
- Rattling noise
Common causes
- Dirty engine oil/sludge
- Stuck VVT solenoid
- Camshaft phaser worn
- Oil passage blockage
- Timing chain stretched
Diagnostic steps
- Check oil level and condition
- Perform oil pressure test
- Inspect VVT solenoid screen for debris
- Monitor camshaft position with scan tool
- Check timing chain condition
Repair notes
Perform oil change if dirty. Replace VVT solenoid. If phaser is worn, replace camshaft phaser assembly.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1