P0002moderate severityPowertrain
Fuel Volume Regulator Control Circuit Range/Performance
on 2000 BMW 525i 2.5L I6 M54 · RWD
What this code means
The fuel volume regulator is not operating within expected parameters. The PCM monitors fuel pressure and compares it to the commanded value.
Symptoms
- Check Engine Light
- Engine surge
- Unstable idle
- Reduced power
Common causes
- Fuel volume regulator sticking
- Low fuel pressure
- Contaminated fuel
- Wiring issue
Diagnostic steps
- Monitor fuel pressure with scan tool
- Compare commanded vs actual pressure
- Inspect regulator for debris
- Check wiring harness
Repair notes
Clean or replace fuel volume regulator.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
29E0
Lambda Additive/Idle Adaptation Limit, Bank 1
29E1
Lambda Additive/Idle Adaptation Limit, Bank 2
29E2
Lambda Multiplicative Part-Load Adaptation Limit, Bank 1
29E3
Lambda Multiplicative Part-Load Adaptation Limit, Bank 2
2A0F
Intake Camshaft Position Sensor Plausibility Fault
2A2C
Camshaft to Crankshaft Correlation Implausible
2A2D
Camshaft to Crankshaft Correlation Offset Fault
2A82
Intake VANOS Position Control Deviation, Bank 1
2A83
Intake VANOS Control Fault / Timing Over-Advanced, Bank 1
2A87
Exhaust VANOS Position Control Deviation, Bank 1