P3002high severityPowertrain
Turbo/Supercharger Boost Control Circuit High
on 2010 BMW M3 E90 4.0L V8 S65 · RWD
What this code means
The signal from the turbo boost control solenoid circuit is above the expected threshold. This can cause overboost or erratic boost control.
Symptoms
- Check Engine Light
- Overboost condition
- Engine knock under load
- Reduced power mode
- Harsh acceleration surge
Common causes
- Open circuit in boost solenoid ground
- Faulty solenoid stuck open
- PCM driver circuit failure
- Damaged wiring harness
- Failed boost pressure sensor
Diagnostic steps
- Measure voltage at boost solenoid connector
- Check solenoid ground circuit continuity
- Test solenoid coil resistance
- Inspect wiring for opens or chafing
- Command solenoid with scan tool and verify operation
Repair notes
Repair open circuit or replace boost control solenoid. Verify no overboost condition exists after repair.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
29CC
Misfire Cylinder 1
29CD
Misfire Cylinder 2
29CE
Misfire Cylinder 3
29CF
Misfire Cylinder 4
29D0
Misfire Cylinder 5
29D1
Misfire Cylinder 6
29D2
Misfire Cylinder 7
29E0
Lambda Additive/Idle Adaptation Limit, Bank 1
29E1
Lambda Additive/Idle Adaptation Limit, Bank 2
29E2
Lambda Multiplicative Part-Load Adaptation Limit, Bank 1