U2064moderate severityNetwork
Module Not Configured
on 2010 BMW M3 E90 4.0L V8 S65 · RWD
What this code means
A control module has been installed but not configured or initialized for operation in this vehicle.
Symptoms
- Module features not working
- System reports module not present
- Cannot access module settings
- Module in manufacturing mode
Common causes
- New module not initialized
- Configuration procedure not performed
- Module programming incomplete
- End-of-line setup not done
Diagnostic steps
- Perform module initialization procedure
- Run post-installation configuration
- Program module with vehicle data
- Complete setup routine
- Verify module exits manufacturing mode
Repair notes
Complete the module initialization and configuration procedure using the manufacturer tool.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Network codes on this vehicle
CC-ID-181
System Check Failed
CC-ID-207
Central Electronics Failure, Stop Vehicle
U0001
High Speed CAN Communication Bus
U0002
High Speed CAN Communication Bus Performance
U0003
High Speed CAN Communication Bus (+) Open
U0004
High Speed CAN Communication Bus (+) Low
U0005
High Speed CAN Communication Bus (+) High
U0006
High Speed CAN Communication Bus (-) Open
U0007
High Speed CAN Communication Bus (-) Low
U0008
High Speed CAN Communication Bus (-) High