C0080low severityChassis
Steering Position Sensor Calibration Not Performed
on 2010 Cadillac Escalade 6.2L V8 · 4WD
What this code means
The steering angle sensor has not been calibrated or the calibration was lost.
Symptoms
- Stability control light on
- ESC inoperative
- Lane departure warning inactive
- Steering center point unknown to module
Common causes
- Battery disconnect cleared calibration
- Alignment performed without recalibration
- Module replacement
- Steering component service
Diagnostic steps
- Perform steering angle sensor calibration with scan tool
- Drive vehicle in a circle to auto-learn center point
- Verify calibration completed successfully
- Check for other stability codes that prevent calibration
Repair notes
Perform steering angle sensor calibration. Most vehicles require a scan tool procedure followed by a driving routine.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0025
LF Wheel Speed Sensor Circuit Intermittent