P1350high severityPowertrain
Ignition Control System
on 2010 Cadillac Escalade 6.2L V8 · 4WD
What this code means
The PCM detected a general malfunction in the ignition control system. This code indicates the PCM is not receiving the expected feedback from the ignition module.
Symptoms
- Check Engine Light
- Engine misfires on multiple cylinders
- Rough running
- No start
- Loss of power
Common causes
- Faulty ignition control module
- Damaged ignition coil pack
- Wiring issue between PCM and IC module
- PCM failure
- Poor ground connection
Diagnostic steps
- Test ignition module output with scope
- Inspect ignition coils
- Check wiring between PCM and IC module
- Verify power and ground to IC module
- Test each coil primary circuit
Repair notes
Replace ignition control module or coil assembly. Check power, grounds, and wiring.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1