1973 CHEVROLET BLAZER

Typical onset: 60,000-100,000 mi

Symptoms: Excessive clunk when shifting into drive or reverse, Vibration through floorboards at idle, Visible sag or torn rubber on crossmember mount

Fix: Replace transmission mount and crossmember bushings. Usually 1.5-2 hours with the truck on a lift. Often the frame-side crossmember insulators are also shot and need replacement simultaneously.

Estimated cost: $200-400

Symptoms: Hard starting when warm, Rough idle and stalling at stop signs, Black smoke or raw fuel smell, Poor fuel economy even for the era

Fix: 1973 was the first year for EGR valves and other emissions band-aids on these engines. Carburetors (Rochester or Quadrajet) need rebuild or replacement, EGR valve cleaning, and vacuum line restoration. Plan 3-5 hours for a proper carb rebuild and tune, more if chasing vacuum leaks.

Estimated cost: $400-900

Symptoms: Visible rust-through on cab corners and rear wheel arches, Soft or perforated frame rails behind cab mounts, Floor pan rust especially driver side, Tailgate and lower fender rot

Fix: This is the killer for these trucks. Frame rust near spring hangers and behind cab mounts can be structural. Proper repair requires cutting out bad sections and welding in new metal. Cab corners are bolt-on patches, but floors require full pan replacement. Budget 20-40 hours for comprehensive rust repair depending on severity.

Estimated cost: $2,500-8,000

Typical onset: 80,000-150,000 mi

Symptoms: Running hot in traffic or on hills, Coolant loss with no visible leaks, White smoke from exhaust on startup, Milky oil on dipstick or cap

Fix: Small-block Chevy heads warp or blow head gaskets when overheated. The 250 I6 is tougher but still vulnerable. Single head gasket job is 6-8 hours; if cylinders need boring or the block is cracked, you're looking at full rebuild or replacement. Many of these engines have 150,000+ miles and marginal compression by now.

Estimated cost: $800-1,400 for head gasket; $3,500-6,000 for rebuild

Typical onset: 100,000-180,000 mi

Symptoms: Grinding into second gear even with clutch fully depressed, Gear oil leaking from front seal, Rattling noise in neutral that goes away when clutch is pressed

Fix: The SM465 4-speed is nearly bulletproof but wears input shaft bearings and second-gear synchros with age. Rebuild involves full teardown, bearing and seal replacement, and synchro ring replacement. Budget 8-12 hours labor plus parts. Many shops charge flat-rate $1,200-1,800 for rebuild.

Estimated cost: $1,200-2,200

Symptoms: Engine stumbles or dies in hot weather after highway driving, Hard restart when hot, Engine cranks but won't fire, Fuel pump clicking but no pressure at carb

Fix: Mechanical fuel pumps mounted on the block fail from diaphragm fatigue or pushrod wear. Vapor lock happens when fuel lines run too close to exhaust manifolds. Pump replacement is 1 hour; rerouting fuel lines and adding heat shields adds another 2-3 hours.

Estimated cost: $150-450