1986 CHEVROLET C30

Typical onset: 80,000-150,000 mi

Symptoms: Clunking when shifting from park to drive or reverse, Excessive driveline vibration under load, Visible transmission sag when inspected from underneath

Fix: Replace rubber transmission mount and crossmember bushings; often find the crossmember cracked from rust or stress. Expect 1.5-2.5 hours labor with transmission supported.

Estimated cost: $150-400

Typical onset: 150,000-250,000 mi

Symptoms: Blue smoke on startup and under acceleration, High oil consumption (quart every 500-800 miles), Low compression test results, poor cold starts

Fix: Full engine rebuild or long block replacement required; rings alone won't fix it if cylinders are tapered or scored. Plan 18-28 hours labor for R&R plus machining wait time. Many opt for reman long block ($1,800-2,800) over rebuild.

Estimated cost: $3,500-6,500

Typical onset: 120,000-180,000 mi

Symptoms: Hard starting especially when warm, Rough idle with black smoke, Loss of power and poor fuel economy, Fuel leaking from injection pump housing

Fix: Stanadyne DB2 pump fails from contaminated fuel or internal wear. Rebuild runs $600-1,200 in parts, plus 6-9 hours labor for removal, timing, and bleeding. Must also replace fuel filter and check/replace lift pump.

Estimated cost: $1,800-3,200

Typical onset: 100,000-180,000 mi

Symptoms: Howling or grinding noise from front axle under load, Gear oil leak from pinion seal or axle tubes, Clunking on turns if spider gears are worn

Fix: Full rebuild includes carrier bearings, pinion bearings, seals, and gear oil. If ring and pinion have pitting, add $400-700 for gear set. Expect 8-12 hours labor; preload and backlash setup is critical.

Estimated cost: $1,200-2,800

Symptoms: Engine stalling or stumbling under load, Fuel starvation symptoms especially uphill, Visible rust flakes in fuel filter housing, Hard starting after sitting

Fix: Steel fuel lines from tank to frame rail rot out; filter clogs rapidly if tank has sediment. Replace fuel filter every 10k-15k miles; if lines are rusty, replace from tank forward with stainless or coated steel. Tank cleaning or replacement often needed. 3-6 hours labor depending on line routing.

Estimated cost: $300-1,200

Typical onset: 120,000-200,000 mi

Symptoms: Knocking noise from bottom end especially when cold, Excessive crankshaft endplay (more than 0.010 inch), Oil pressure drops below 10 psi at hot idle, Metallic debris in oil pan

Fix: Requires full short block rebuild or replacement; thrust bearing failure (center main) is common from clutch abuse or worn pilot bushing. Engine R&R plus machine work runs 20-30 hours total. Many shops recommend full rebuild at this point.

Estimated cost: $4,500-8,000

Symptoms: Transmission fluid dripping near radiator or frame rails, Low fluid level on dipstick without external puddles, Rusty or corroded steel lines visible along frame

Fix: Factory steel lines rot out at fittings and bends; replace with preformed or universal stainless lines. Also check radiator-integrated cooler for internal leaks (fluid in coolant). 1.5-3 hours labor for line replacement.

Estimated cost: $200-500