Free API

1992 CHRYSLER LEBARON

2.5L I4 TurboFWDAUTOMATICgasturbo
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this LeBaron
5-Year Cost of Ownership
$32,248 maintenance + known platform issues
~$6,450/yr · 540¢/mile equivalent · $6,309 maintenance + $6,089 expected platform issues
Compare this engine
vs
3.0L Mitsubishi V6
vs
2.2L I4 Turbo
vs
3.0L V6

Common Problems & Known Issues

The 1992 LeBaron, particularly the AA-body coupe/convertible, suffers from chronic automatic transmission failures and head gasket issues on the 3.0L Mitsubishi V6. The turbo four-cylinders are more durable but face their own oil consumption and sensor problems.

A604 (41TE) Automatic Transmission Failure

Common · high severity
Typical onset: 80,000-130,000 mi
Symptoms: Harsh or delayed shifts, especially 2-3 upshift, Slipping in overdrive or loss of reverse, Limp mode with check engine light, trans stuck in second gear, Whining noise from torque converter or pump
Fix: The A604/41TE is notorious for solenoid pack failures, worn clutch packs, and valve body issues. Most require full rebuild or replacement. Rebuild takes 12-16 hours; used trans swap 8-10 hours. Solenoid pack alone (if caught early) is 4-5 hours.
Estimated cost: $1,800-3,200

3.0L V6 Head Gasket Failure

Common · high severity
Typical onset: 90,000-140,000 mi
Symptoms: White smoke from exhaust, sweet smell, Coolant loss with no visible leaks, Overheating or erratic temp gauge, Milky oil on dipstick or oil cap
Fix: Mitsubishi 3.0L V6 head gaskets fail between cylinders or into coolant passages. Requires both heads off, surface inspection, new gaskets, timing belt/water pump while apart. 14-18 hours labor. If heads are warped, add machining or replacement.
Estimated cost: $2,200-3,800

Oil Consumption and Valve Stem Seals (2.2L/2.5L Turbo)

Common · medium severity
Typical onset: 100,000-150,000 mi
Symptoms: Blue smoke on cold start or deceleration, Burning one quart of oil every 500-800 miles, Fouled spark plugs, misfires, Oil smell from exhaust
Fix: Turbo four-cylinders wear valve stem seals and piston rings. Seal replacement alone is 8-10 hours (head off). If rings are gone, you're looking at piston replacement or full rebuild at 20+ hours. Many opt for used engines instead.
Estimated cost: $1,200-2,500

Turbocharger Failure (2.2L/2.5L Turbo)

Occasional · medium severity
Typical onset: 110,000-160,000 mi
Symptoms: Loss of power, sluggish acceleration, Loud whistling or grinding noise under boost, Excessive black or blue smoke, Check engine light with boost pressure codes
Fix: Turbos fail from oil starvation, bearing wear, or wastegate sticking. Replacement turbo (aftermarket or reman) is 4-6 hours. Must inspect oil feed/return lines and replace if clogged. Neglected oil changes are the primary cause.
Estimated cost: $800-1,600

Speed Sensor and Computer Issues (A604 Trans)

Common · medium severity
Typical onset: 70,000-120,000 mi
Symptoms: Speedometer erratic or dead, Transmission stuck in limp mode (second gear only), ABS light on (if equipped), No-start or stalling due to PCM miscommunication
Fix: Output speed sensor on the trans or vehicle speed sensor fails, confusing the PCM and TCM. Sensor replacement is 1-2 hours. Sometimes the issue is corroded wiring at the trans connector — clean and reseal. PCM/TCM failures are rarer but require remanufactured units.
Estimated cost: $150-600

Fuel Pump and Pressure Regulator Failure

Occasional · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: No-start or long cranking before start, Stalling at idle or under load, Hesitation or stumble on acceleration, Check engine light with lean or fuel pressure codes
Fix: In-tank fuel pump fails or pressure regulator leaks. Pump replacement requires dropping the tank, 3-4 hours labor. Pressure regulator (if external on 3.0L V6) is easier, 1-2 hours. Test fuel pressure before replacing.
Estimated cost: $400-900

Convertible Top Hydraulic Cylinder and Motor Failures

Occasional · low severity
Symptoms: Top operates slowly or stops mid-cycle, One side lifts unevenly, Hydraulic fluid leaks at cylinders, Motor runs but top doesn't move
Fix: Convertible top hydraulic pumps, cylinders, and hoses leak or seize from age and lack of use. Motor replacement is 2-3 hours; cylinders add another 3-4 hours each. Used parts are scarce. Maintain by cycling top monthly and checking fluid.
Estimated cost: $600-1,800
Owner tips
  • Change A604 transmission fluid every 30,000 miles with Mopar ATF+3 or ATF+4 — it buys time but won't prevent eventual failure
  • On turbo models, use synthetic oil and change every 3,000 miles to protect turbo bearings and valve seals
  • Inspect timing belt on 3.0L V6 every 60,000 miles — interference engine will destroy itself if belt breaks
  • Flush cooling system every two years on 3.0L to slow head gasket degradation
  • If buying a convertible, budget $1,000-2,000 for top motor/hydraulics unless seller proves recent service
Only if you're handy with transmissions or can find a rare example with a manual gearbox and the 2.5L turbo — otherwise the A604 is a ticking time bomb that makes these cars more trouble than they're worth.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 1992 Chrysler LeBaron

508 jobs across 17 categories

body (31)

brakes (41)

cooling (21)

drivetrain (24)

electrical (75)

engine (68)

exhaust (22)

interior (24)

maintenance (30)

steering (19)

suspension (47)

transmission (44)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →