The 2014 Avenger is Dodge's last gasp of this mid-size sedan before discontinuation, built on an aging platform with known powertrain durability issues. The 2.4L World Engine and early 62TE transmissions are the primary reliability concerns, while the 3.6L Pentastar is more robust but still suffers from platform-wide cooling and mount problems.
2.4L World Engine Internal Failure (Piston Ring Land / Bearing Failure)
Common · high severity
Typical onset: 80,000-140,000 mi
Symptoms: Excessive oil consumption (quart per 1,000 mi or worse), Cold-start knock that persists, Metal shavings in oil during changes, Loss of compression on one or more cylinders, Catastrophic failure with rod knock or seized engine
Fix: The 2.4L World Engine has a notorious pattern of piston ring land failures and bearing wear. Piston rings crack, allowing blowby and oil burning, which accelerates bearing damage. Fix requires short block replacement or full engine rebuild. Plan 18-24 labor hours for short block R&R, more if internal damage requires machine work. Many owners opt for used engine swaps (12-16 hours) to save cost.
Estimated cost: $3,500-6,500
62TE Transmission Oil Cooler Line Failure and Internal Damage
Common · high severity
Typical onset: 60,000-110,000 mi
Symptoms: Transmission fluid in coolant or coolant in trans fluid (strawberry milkshake fluid), Harsh or delayed shifts, Slipping between gears, especially 2-3 or 4-5, Transmission overheating warnings, Complete loss of forward gears
Fix: The 62TE six-speed automatic has an internal cooler circuit that fails, cross-contaminating coolant and ATF. Once contaminated, the trans typically needs rebuild or replacement, not just a cooler swap. External cooler delete/bypass is the fix, but damage is often done by the time symptoms appear. Cooler alone is 3-4 hours; if trans is damaged, figure 12-16 hours for R&R and rebuild, or 8-10 for used unit swap.
Estimated cost: $2,800-5,200
Transmission and Engine Mount Collapse
Common · medium severity
Typical onset: 70,000-120,000 mi
Symptoms: Excessive vibration at idle, especially in Drive, Clunking when shifting into gear or accelerating from stop, Engine rocking forward/back visibly during throttle application, Increased cabin noise and harshness
Fix: The hydraulic engine and transmission mounts deteriorate and collapse, especially the lower torque mount and rear trans mount. These are wear items on this platform, but they fail earlier than most. Replacing all three mounts (upper engine, lower torque, trans) takes about 4-5 hours total. Do them all at once since labor overlaps.
Estimated cost: $450-750
3.6L Pentastar Cylinder Head Gasket Seepage (Left Side)
Occasional · medium severity
Typical onset: 90,000-150,000 mi
Symptoms: Coolant seepage or crust around left cylinder head, Slow coolant loss without visible external leaks, Slight overheating under load or hot weather, Occasional rough idle when coolant gets low
Fix: The left (driver side) head gasket on the 3.6L tends to weep coolant externally over time. Not as catastrophic as internal failures, but requires head removal to fix properly. Left head is easier access than right. Plan 8-10 hours for left head gasket R&R, including resurfacing if needed. Do both heads if budget allows since right side often follows within 20k-30k miles.
Estimated cost: $1,800-2,800
TIPM (Totally Integrated Power Module) Failures
Occasional · medium severity
Symptoms: Intermittent no-start with no crank, Fuel pump not priming, Wipers, windows, or horn operating on their own, Warning lights flickering or staying on, Gauges going haywire or instrument cluster blackout
Fix: The TIPM is Chrysler's Achilles heel across this era. It's the central fuse/relay box that controls everything electrical. When relays fail internally, you get bizarre electrical gremlins or total failure to start. Used to be a common warranty fix; now out of warranty, these units cost serious money. Replacement is simple (1-1.5 hours), but the part itself is expensive. Some shops offer TIPM repair services for half the cost of new.
Estimated cost: $800-1,400
Fuel Filter Clogging and Pump Stress (2.4L Particularly)
Occasional · medium severity
Typical onset: 80,000-130,000 mi
Symptoms: Hard starting after sitting overnight, Sputtering or hesitation under acceleration, Fuel pump whining louder than normal, Engine dying at idle or under load, Check engine light with fuel trim or lean codes
Fix: The 2.4L seems particularly sensitive to fuel filter clogging, likely due to tighter tolerances in the direct-injection system. The filter is part of the pump module in the tank, so it's a tank-drop job. Plan 3-4 hours for pump/filter module replacement. If caught early, just the filter assembly can be swapped; if the pump is damaged from running dirty, you're replacing the whole module.
Estimated cost: $600-950
Owner tips
If buying a 2.4L, verify oil consumption history and request an oil analysis; walk away if consumption exceeds 1 quart per 2,000 miles.
Change transmission fluid every 50k miles regardless of 'lifetime' claims, and inspect cooler lines for seepage at every service.
Budget for all three engine/trans mounts as a 100k-mile service item on this platform.
The 3.6L Pentastar is the more durable engine choice; avoid the 2.7L V6 entirely if possible (internal sludge issues).
Check TIPM function carefully during pre-purchase inspection; cycle all electrical functions multiple times.
Hard pass unless it's a 3.6L Pentastar with documented fluid service history and priced under $6k; the 2.4L is a ticking time bomb, and the 62TE transmission needs expensive preventive care that most owners skip.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
Fitment notes: Standard top post terminals; battery located under hood
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Every control module on the 2008-2014 Dodge Avenger — where it lives, replacement time, and what it takes to program a replacement. Modules marked dealer / factory tool won't work after a part swap alone — budget for programming.
Electric Power Steering Module (EPS)2.5 hr R&Rdealer / factory tool +0.8 hr▸ programming details
📍 Steering column or rack assembly
🔧 wiTECH
⚠️ 2011+ models; calibration and steering angle sensor reset required
Body Control Module (BCM)1.8 hr R&Rdealer / factory tool +0.8 hr▸ programming details
📍 Behind left side of instrument panel or integrated in TIPM
🔧 wiTECH or Autel MaxiSys
⚠️ Configuration required for vehicle options; may be integrated with TIPM on some models
⚠️ HID or adaptive headlamp models only; calibration may be needed
Aftermarket tool coverage varies by software version and vehicle build — treat "aftermarket tool" rows as "usually possible" and verify against your tool maker's coverage list before promising a customer. Spot a wrong location or hour? Tell us — corrections ship fast here.
Chrysler (FCA US LLC) is recalling certain model year 2011-2014 Chrysler 200, 2010 Chrysler Sebring, 2010-2012 Dodge Caliber and 2010-2014 Jeep Patriot, Compass and Dodge Avenger vehicles. The Occupant Restraint Control (OCR) module may short circuit, preventing the frontal air bags, seat belt pretensioners, and side air bags from deploying in the event of a crash.
Consequence: If the frontal air bags, seat belt pretensioners, and side air bags are disabled, there is an increased risk of injury to the vehicle occupants in the event of a vehicle crash that necessitates deployment of these safety systems.
Remedy: Chrysler will notify owners, and dealers will replace the OCR, free of charge. Interim letters informing owners that parts are not available yet were mailed on October 26, 2016. The recall began on August 15, 2017. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is S61.
Wiper blades
Sedan body style, no rear wiper. Standard hook-type attachment.
Size-standard part numbers — verify your connector type before buying. Rear blades are model-specific; check the package's vehicle list.
Fuel economy figures are EPA data via fueleconomy.gov (median across matching trims). Performance figures are compiled estimates for the 2014 Dodge Avenger 3.6L V6 Pentastar and can vary by trim.
🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years and Jeff Moore · Master Lexus & Toyota Mechanic · 20+ years.