Free API

2015 DODGE CHALLENGER

6.2L V8 Hellcat (707hp)RWDAUTOMATICgassupercharged
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this Challenger
5-Year Cost of Ownership
$40,536 maintenance + known platform issues
~$8,107/yr · 680¢/mile equivalent · $7,715 maintenance + $9,971 expected platform issues
Compare this engine
vs
3.6L V6 Pentastar
vs
5.7L V8 Hemi
vs
6.4L V8 Hemi 392
Common Problems & Known Issues

The 2015 Challenger is a solid retro muscle platform, but the 5.7L and 6.4L Hemi engines are notorious for lifter/cam failures after 60k miles, and the 8-speed ZF transmission can develop cooler and valve body issues. The Hellcat sees forced-induction stress on bottom-end components.

Hemi MDS Lifter and Camshaft Failure (5.7L & 6.4L)

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: Ticking or tapping noise on cold start that persists, Check engine light with misfire codes P0300-P0308, Loss of power, rough idle, Metal shavings in oil
Fix: The MDS (cylinder deactivation) lifters collapse or the cam lobes wipe out. Requires heads-off teardown, camshaft replacement, all 16 lifters, pushrods inspection, and often rocker arms. 16-20 labor hours at a competent shop. Some owners delete MDS with aftermarket cam to prevent recurrence.
Estimated cost: $4,000-7,000

8-Speed ZF Transmission Oil Cooler Leaks

Common · medium severity
Typical onset: 50,000-90,000 mi
Symptoms: Transmission fluid pooling under vehicle, driver side, Burnt smell after highway driving, Harsh shifting or slipping when fluid is low
Fix: The cooler lines or the cooler itself develop leaks at crimp joints. External cooler replacement is straightforward, 2-3 hours labor, but you'll need fluid flush and often a new filter while you're in there. If ignored, low fluid destroys clutch packs.
Estimated cost: $600-1,200

Hellcat Bottom-End Bearing Failures (6.2L Supercharged)

Occasional · high severity
Typical onset: 40,000-80,000 mi
Symptoms: Knocking or rattling from deep in engine, worse under load, Low oil pressure warning, Metal debris in oil filter during changes, Catastrophic failure: sudden loss of power, engine seizes
Fix: Rod bearings and sometimes mains wear prematurely, especially in cars driven hard or with modified tunes. Requires full engine-out teardown, crank polishing or replacement, all bearings, and piston inspection. 30-40 hours labor for short-block rebuild. Some owners go forged internals at this point.
Estimated cost: $8,000-15,000

TIPM (Totally Integrated Power Module) Failures

Occasional · high severity
Symptoms: Intermittent no-start, no crank, Fuel pump not priming (no hum when key turned), Random electrical gremlins: windows, wipers, gauges acting erratically, Stalling while driving
Fix: The TIPM is Chrysler's Achilles heel—it's the fuse/relay box on steroids. When internal relays fail, the fuel pump circuit dies or the starter won't engage. Replacement is 2-3 hours labor, but the part runs $400-800. Programming required. Some independent shops offer TIPM repair services for half the cost.
Estimated cost: $800-1,400

Transmission Valve Body and Solenoid Issues (8HP70/90)

Occasional · medium severity
Typical onset: 70,000-130,000 mi
Symptoms: Harsh or delayed 2-3 or 3-4 shifts, Transmission slipping or flaring between gears, Check engine light with solenoid or pressure control codes, Limp mode (stuck in 2nd or 3rd gear)
Fix: The ZF 8-speed develops valve body wear or solenoid pack failures. Requires pan drop, valve body removal, solenoid replacement or full valve body swap. 4-6 hours labor. Fluid and filter service is mandatory during repair. Early software updates help, but hardware eventually fails.
Estimated cost: $1,200-2,500

Pentastar V6 Oil Cooler and Head Gasket Seepage (3.6L)

Occasional · low severity
Typical onset: 80,000-150,000 mi
Symptoms: Oil weeping from front of engine near timing cover, Coolant smell or slight loss with no visible external leak, Oil in coolant reservoir (milky appearance)
Fix: The 3.6L oil cooler housing gasket and cylinder head gaskets can seep over time. Oil cooler is 3-4 hours with timing cover removal; head gaskets require heads-off, 12-16 hours. Most seepage is slow and non-critical, but mixing fluids means head gasket replacement is urgent.
Estimated cost: $800-3,500
Owner tips
  • Change oil every 5k miles on Hemis with MDS—the lifter issue is exacerbated by extended intervals and low-quality oil.
  • Service the 8-speed ZF transmission fluid and filter at 60k miles even though Dodge says 'lifetime'—heat kills this trans.
  • Hellcat owners: install an oil catch can and monitor oil pressure religiously; consider upgraded bearings if tracking or tuning.
  • Check TIPM function during pre-purchase: cycle key, listen for fuel pump prime, test all windows and accessories.
The V6 and non-Hellcat V8s are solid buys if the cam/lifter job has been done or you budget for it; avoid high-mileage Hellcats unless engine internals are documented as upgraded.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
495 jobs across 17 categories

body (31)

brakes (36)

cooling (21)

drivetrain (24)

electrical (75)

engine (71)

exhaust (24)

hvac (23)

interior (24)

maintenance (32)

steering (19)

suspension (42)

transmission (42)

🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →