Free API

2000 DODGE DAKOTA

4.7L V84WDAUTOMATICgas
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this Dakota
5-Year Cost of Ownership
$10,025 maintenance + known platform issues
~$2,005/yr · 170¢/mile equivalent · $6,180 maintenance + $3,145 expected platform issues
Compare this engine
vs
3.7L V6
vs
3.9L V6 Magnum

Common Problems & Known Issues

The 2000 Dakota is a solid mid-size truck hampered by transmission weakness and front-end wear. The 3.9L V6 and 4.7L V8 are generally reliable, but the 46RE/545RFE automatics are the platform's Achilles heel.

Automatic Transmission Failure (46RE/545RFE)

Common · high severity
Typical onset: 80,000-140,000 mi
Symptoms: Delayed engagement into Drive or Reverse, Harsh 2-3 shift or slipping under load, Transmission overheating, burnt fluid smell, Complete loss of forward gears
Fix: Rebuild requires 8-12 hours labor; often includes overdrive solenoid pack, clutch packs, and governor pressure sensor. Cooler line replacement critical to prevent repeat failures. External cooler highly recommended.
Estimated cost: $1,800-3,200

Plenum Gasket Failure (3.9L V6 / 5.2L/5.9L V8)

Common · medium severity
Typical onset: 60,000-120,000 mi
Symptoms: Rough idle, stumbling on acceleration, Oil consumption without visible leaks, Pooled oil in intake manifold valley, Check engine light with lean codes
Fix: Intake manifold removal required; 4-6 hours labor. Use updated Hughes Engines or Fel-Pro gasket, NOT factory Mopar part. Often find oil-soaked injectors needing cleaning.
Estimated cost: $450-850

Front Upper Ball Joint Separation

Common · high severity
Typical onset: 70,000-110,000 mi
Symptoms: Clunking over bumps, especially when turning, Wandering steering, pulls to one side, Uneven tire wear on inside edge, Visible play when prying on wheel at 12-6 o'clock
Fix: Subject to recall but many missed the window. Replace both uppers as a pair; 3-4 hours labor. Use Moog K7397 or equivalent quality — cheap parts fail in 20k miles. Alignment mandatory after.
Estimated cost: $400-700

Brake Line Corrosion and Failure

Occasional · high severity
Symptoms: Soft or spongy brake pedal, Visible rust perforation on steel lines near rear axle, Brake fluid leaking at frame rail routing, Pedal goes to floor under hard braking
Fix: Salt-belt trucks see catastrophic line rust. Full brake line replacement (all four corners) runs 5-7 hours with pre-fabricated kit. Do NOT patch — replace the entire system when one section fails.
Estimated cost: $600-1,100

Fuel Pump Failure

Occasional · medium severity
Typical onset: 90,000-150,000 mi
Symptoms: No-start or extended cranking when hot, Stalling at idle after highway driving, Sputtering under acceleration, loss of power, Fuel pressure below 49 psi at key-on
Fix: In-tank pump; bed removal makes job easier (2.5 hours) vs dropping tank (4 hours). Replace strainer and check filler neck for rust. Mopar or Bosch pumps only — aftermarket junk fails in months.
Estimated cost: $450-750

Crankshaft Position Sensor Intermittent

Common · medium severity
Typical onset: 80,000-140,000 mi
Symptoms: Random no-start, cranks but won't fire, Stalling while driving with immediate restart ability, No check engine light, no codes stored, Heat-related — fails hot, works when cool
Fix: Located at bellhousing, 0.5-1 hour labor. Classic Mopar problem — sensor windings break down with heat cycling. Keep a spare in the glovebox; it's a roadside-fixable part with basic tools.
Estimated cost: $80-180

Dashboard Cracking and Warping

Common · low severity
Symptoms: Horizontal cracks above instrument cluster, Warping near defroster vents, UV degradation makes plastic brittle, Affects resale value and windshield seal integrity
Fix: Cosmetic but universal on sun-belt trucks. Aftermarket dash covers are $100-200. Full dash replacement requires complete interior removal (12+ hours) and is cost-prohibitive. Accept it or cover it.
Estimated cost: $150-300
Owner tips
  • Change transmission fluid every 30k miles with ATF+4 spec only — extends trans life significantly
  • Inspect upper ball joints annually; they fail with minimal warning and cause loss of control
  • Use synthetic oil in the 4.7L V8 to prevent sludge buildup in the cam towers
  • Replace plenum gasket proactively at 80k if oil consumption starts — cheap insurance against engine damage
  • Rust-proof brake lines and fuel lines if in salt states; these rot from inside-out
Buy the 3.9L V6 or 4.7L V8 if the transmission has been rebuilt or shows clean fluid and no slip — otherwise budget $2k-3k for inevitable trans work within a year.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 2000 Dodge Dakota

511 jobs across 17 categories

body (34)

brakes (41)

cooling (21)

drivetrain (33)

electrical (74)

engine (65)

exhaust (22)

interior (24)

maintenance (31)

steering (23)

suspension (46)

transmission (42)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →