Free API

2022 DODGE DURANGO

6.2L V8 Supercharged4WDAUTOMATICgassupercharged
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this Durango
5-Year Cost of Ownership
$14,643 maintenance + known platform issues
~$2,929/yr · 240¢/mile equivalent · $7,715 maintenance + $4,328 expected platform issues
Compare this engine
vs
3.6L V6 Pentastar
vs
5.7L V8 Hemi
vs
6.4L V8 392

Common Problems & Known Issues

The 2022 Durango rides on a proven platform but suffers from aging transmission tech and powertrain cooling issues, particularly in V8-equipped models. Most problems show up after warranty expires, around 60k-100k miles.

Transmission Oil Cooler Failure

Common · high severity
Typical onset: 60,000-90,000 mi
Symptoms: Transmission fluid leaking from cooler lines or radiator area, Transmission overheating warnings on dash, Pink or milky fluid in coolant reservoir (cross-contamination), Harsh shifting or delayed engagement when hot
Fix: Replace transmission cooler and flush both cooling system and transmission. If cross-contamination occurred, full transmission flush or rebuild may be needed. 3-5 hours labor for cooler alone, 8-12 hours if transmission damaged.
Estimated cost: $800-$1,200 for cooler replacement, $3,500-$6,000 if transmission rebuild required

ZF 8-Speed Transmission Shudder and Premature Wear

Common · medium severity
Typical onset: 50,000-80,000 mi
Symptoms: Shudder or vibration during 6th-8th gear lockup, especially 40-50 mph, Harsh 2-3 or 3-4 upshifts under light throttle, Transmission slipping out of gear momentarily, Check engine light with torque converter clutch codes
Fix: Start with software flash and fluid/filter service using OEM Mopar fluid (critical). If shudder persists, torque converter replacement needed. Some cases require valve body or input shaft bearing replacement. 2-3 hours for fluid service, 8-10 hours for torque converter.
Estimated cost: $400-$600 for fluid service, $2,200-$3,500 for torque converter replacement

Timing Chain Stretch (3.6L Pentastar)

Occasional · high severity
Typical onset: 80,000-120,000 mi
Symptoms: Rattling noise on cold start for first 2-3 seconds, Check engine light with cam/crank correlation codes (P0016, P0017), Rough idle or misfires, Metal shavings in oil during changes
Fix: Replace both timing chains, guides, tensioners, and cam phasers. This is an interference engine—chain failure means bent valves and total engine damage. 12-15 hours labor, must drop subframe for access.
Estimated cost: $2,800-$4,200

Hemi Valve Seat Failures (5.7L/6.4L)

Occasional · high severity
Typical onset: 70,000-110,000 mi
Symptoms: Sudden loss of power and rough running, Metallic rattling or ticking that worsens rapidly, Cylinder misfire codes, typically one bank, Catastrophic failure can dump valve seat into cylinder
Fix: Complete valve job required—machine heads, replace all valve seats and guides. In severe cases, piston and cylinder wall damage requires engine replacement. 18-24 hours for head work per bank, 25-35 hours for complete rebuild.
Estimated cost: $3,500-$5,500 per head, $8,000-$12,000+ for full engine work

Rear Transmission Mount Failure

Common · low severity
Typical onset: 40,000-70,000 mi
Symptoms: Clunk when shifting from Park to Drive or Reverse, Vibration at idle in gear, Excessive driveline movement visible under throttle
Fix: Replace rear transmission mount and crossmember bushings. Simple job but requires transmission support. 1.5-2 hours labor.
Estimated cost: $250-$450

Electronic Stability Control Module Failure

Occasional · medium severity
Symptoms: ABS, traction control, and ESC warning lights all illuminated, Loss of ABS and stability control function, Speedometer and cruise control inoperative, Codes for wheel speed sensors but sensors test fine
Fix: Replace ABS/ESC module (covered by recall 23V-519 for some VINs, check first). Module located under hood, requires programming. 2-3 hours labor including programming.
Estimated cost: $0 if recall applies, $1,200-$1,800 if not covered

Liftgate Strut Failure and Latch Issues

Common · low severity
Typical onset: 30,000-60,000 mi
Symptoms: Liftgate won't stay open or drops suddenly (dangerous), Power liftgate opens partially then reverses, Latch won't catch or won't release, Multiple beeps and "liftgate ajar" warning
Fix: Replace liftgate struts (both sides) and recalibrate power liftgate module. Some cases need latch assembly replacement (recall 23V-130 for certain VINs). 1.5-2.5 hours labor.
Estimated cost: $350-$650 for struts and calibration, add $400-$600 if latch needed
Owner tips
  • Change transmission fluid every 60k miles with OEM Mopar ZF fluid—aftermarket fluids cause shudder issues
  • On 3.6L engines, inspect timing chain tension at every oil change after 60k miles—listen for cold-start rattle
  • V8 owners: use Top Tier gasoline and Italian Tune-Up monthly to prevent carbon buildup on valve seats
  • Check transmission cooler lines and crossmember for leaks during every service—early catch prevents $4k+ repairs
Solid tow rig and family hauler, but budget $2k-3k for transmission work between 60-80k miles—V8 models are gambles on valve seats after 70k.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 2022 Dodge Durango

497 jobs across 17 categories

body (30)

brakes (36)

cooling (21)

drivetrain (33)

electrical (75)

engine (70)

exhaust (22)

hvac (23)

interior (24)

maintenance (32)

steering (22)

suspension (48)

transmission (30)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →