drivetrain
Wheel Bearing Repack & Adjust - Front (Serviceable)
for 1978 Ford Econoline 300ci I6 · RWD
🔧Does this apply to your car? Serviceable tapered-bearing hubs only (most pre-1990 RWD vehicles). Bearing tension is set by PRELOAD — tighten the spindle nut while rotating the wheel, then back off to the adjustment spec — not by a torque value. Sealed hub assemblies on modern vehicles are replaced, not repacked.
🔓 Step-by-step procedure: not written yet
For $3, we'll write the full Wheel Bearing Repack & Adjust - Front (Serviceable) procedure for the 1978 Ford Econoline — steps, torque values, tips — and it becomes free for every owner on earth, forever, with your name on it. Usually live within the hour.
Labor Hours
1.2hr
Range: 0.9–1.6 hr
Data quality
Book-style estimate
Not yet expert-verified. Have the book time? Correct it below — takes 30 seconds.
At $110/hr (independent shop)
$132
Estimated labor cost. Parts not included.
Technician notes
- Preload procedure: tighten spindle nut while rotating, back off per spec, new cotter pin.
- Replace grease seals — never reuse.
- Van (Econoline) front ends of this era vary — confirm the kingpin setup matches the pickup pattern before quoting.