P3656moderate severityPowertrain
Port and Direct Injection System Imbalance
on 2019 Ford F-150 3.5L V6 EcoBoost · RWD
What this code means
In dual-injection systems (combined port and direct injection), the balance between PFI and GDI fueling is incorrect.
Symptoms
- Check Engine Light
- Rough idle
- Knock or ping under load
- Poor emissions
- Fuel economy reduced
- Cold start misfires
Common causes
- Port injector partial blockage
- GDI injector drift
- Fuel pressure imbalance between systems
- PCM fuel strategy calibration error
- Intake runner flap affecting port injection
Diagnostic steps
- Compare port vs direct injection fuel trim data
- Test individual port injector flow
- Test GDI injector flow rates
- Monitor knock sensor activity
- Check intake runner valve operation
Repair notes
Clean or replace affected injectors. Recalibrate fuel split strategy if software update is available. Check intake runner valves.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1