P3021high severityPowertrain
CVT Primary Pulley Speed Sensor Circuit
on 2012 Ford Focus 2.0L I4 GDI · FWD
What this code means
The primary (input) pulley speed sensor in the CVT is reporting erratic or no signal. The TCM requires this signal for ratio control.
Symptoms
- Check Engine Light
- Transmission stuck in one ratio
- Erratic shifting
- Speedometer malfunction
- Limp mode
- Delayed engagement
Common causes
- Faulty primary pulley speed sensor
- Damaged tone ring
- Sensor wiring damage
- Contaminated sensor tip
- TCM input circuit failure
Diagnostic steps
- Read primary pulley speed PID
- Inspect sensor connector and wiring
- Check tone ring condition
- Test sensor resistance and air gap
- Compare primary to secondary sensor readings
Repair notes
Replace primary pulley speed sensor. Inspect tone ring for damage or contamination.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1