P3003moderate severityPowertrain
Turbo/Supercharger Boost Pressure Sensor Circuit Intermittent
on 2013 Ford Focus 2.0L I4 EcoBoost · FWD
What this code means
The boost pressure sensor signal is intermittent, causing erratic boost control. The PCM detects signal dropouts or sudden voltage changes.
Symptoms
- Check Engine Light intermittent
- Fluctuating boost gauge
- Inconsistent power delivery
- Occasional limp mode
- Surging under load
Common causes
- Loose boost pressure sensor connector
- Damaged sensor wiring
- Faulty boost pressure sensor
- Vibration-related intermittent contact
- Corroded sensor pins
Diagnostic steps
- Monitor boost pressure PID for signal dropouts
- Wiggle test on sensor connector while monitoring data
- Inspect sensor connector pins for corrosion
- Check wiring harness routing near heat sources
- Swap sensor with known good unit if available
Repair notes
Replace boost pressure sensor or repair intermittent wiring connection.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1