Free API

2002 GMC JIMMY

4.3L V6FWDAUTOMATICgas
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this Jimmy
5-Year Cost of Ownership
$10,668 maintenance + known platform issues
~$2,134/yr · 180¢/mile equivalent · $6,165 maintenance + $3,803 expected platform issues
Compare this engine
vs
4.3L V6 Vortec

Common Problems & Known Issues

The 2002 GMC Jimmy with the 4.3L Vortec V6 is a sturdy GMT330 platform truck that typically suffers from transmission issues, intake gasket leaks, and fuel system problems. The 4L60-E automatic is the Achilles' heel, but the engine itself is generally durable if properly maintained.

4L60-E Automatic Transmission Failure

Common · high severity
Typical onset: 120,000-180,000 mi
Symptoms: Slipping between gears, especially 2nd to 3rd, Harsh or delayed shifting, No reverse or intermittent reverse, Burnt transmission fluid smell
Fix: Full rebuild or replacement typically required. Shift solenoids and pressure control solenoid fail first, but by the time symptoms are obvious, internal clutch packs are often damaged. Rebuild takes 12-16 hours including R&R, fluid, and converter.
Estimated cost: $2,200-3,800

Lower Intake Manifold Gasket Leak

Common · medium severity
Typical onset: 80,000-140,000 mi
Symptoms: External coolant leak at front of engine, below throttle body, Coolant in oil (milky dipstick) in severe cases, Overheating or low coolant warnings, Rough idle when cold
Fix: Classic Vortec 4.3L problem—plastic gasket deteriorates. Must remove upper plenum, fuel rails, and accessories. Always replace upper gasket set at same time. 5-7 hours labor.
Estimated cost: $650-1,100

Fuel Pump Failure

Common · high severity
Typical onset: 100,000-160,000 mi
Symptoms: No-start condition, cranks but won't fire, Stalling at idle or when hot, Loss of power under load, Whining noise from fuel tank
Fix: In-tank pump accessible by dropping tank or cutting access panel through bed floor (some techs do this, not factory-approved). If dropping tank, replace fuel filter, strainer, and check filler neck for rust. 3-4 hours labor for tank drop method.
Estimated cost: $450-750

Distributor and Ignition Component Failure

Occasional · medium severity
Typical onset: 90,000-150,000 mi
Symptoms: Random misfire codes, multiple cylinders, No-start or intermittent stalling, Rough running, especially when wet, Tach bouncing or dying while driving
Fix: The Vortec distributor uses an optical sensor that fails. Cap, rotor, and plug wires also deteriorate. Replace entire distributor assembly plus wires for reliability. 2-3 hours labor.
Estimated cost: $400-650

Transfer Case Encoder Motor/Shift Motor Failure (4WD models)

Common · medium severity
Typical onset: 70,000-120,000 mi
Symptoms: Service 4WD light illuminated, Unable to engage or disengage 4WD, Grinding or clicking noise from transfer case area when switching modes, Stuck in 4WD or 2WD
Fix: The NP233 transfer case uses an electric shift motor that fails internally. Motor mounts on driver side of transfer case. Relatively easy repair: drain fluid, unbolt motor, replace, refill. 1.5-2 hours labor.
Estimated cost: $250-450

EVAP System Leaks and Fuel Tank Issues

Occasional · low severity
Typical onset: N/A (age and rust related)
Symptoms: Check engine light with P0442 or P0455 codes (EVAP leak), Fuel smell around vehicle, Difficulty filling tank, pump clicks off repeatedly, Visible rust or seepage on fuel tank
Fix: Common culprits: cracked vent hoses, failed EVAP canister, rusted fuel tank (especially in salt states), or faulty fuel tank pressure sensor. Tank replacement requires 3-4 hours; hoses and sensors are quicker fixes (1-2 hours).
Estimated cost: $300-1,200

Front Differential and CV Axle Wear (4WD models)

Occasional · medium severity
Typical onset: 100,000-150,000 mi
Symptoms: Clunking on acceleration or turning (CV axles), Whining or growling from front differential, Grease splatter on inside of wheel (torn CV boot), Vibration at highway speeds
Fix: CV axles wear at inner and outer joints; boots tear and contaminate bearings. Front diff can develop bearing noise or pinion seal leaks. CV axle replacement: 2-3 hours per side. Diff service or rebuild: 4-6 hours.
Estimated cost: $350-900 (axles); $800-1,500 (diff work)
Owner tips
  • Change transmission fluid and filter every 50,000 miles—4L60-E longevity depends on it. Use Dexron VI.
  • Inspect intake manifold area for coolant seepage annually; catching it early prevents internal engine damage.
  • Use quality fuel with detergent additives to keep injectors clean; these trucks are sensitive to fuel quality.
  • Check transfer case fluid level every oil change on 4WD models—leaks are common and lead to expensive failures.
  • Replace distributor cap, rotor, and plug wires as a set around 100k miles; don't cheap out on ignition parts.
Solid truck if the transmission has been maintained or already rebuilt, but budget $3k-5k for deferred maintenance on any high-mileage example—pass if there's any transmission slip.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 2002 GMC Jimmy

503 jobs across 17 categories

body (30)

brakes (41)

cooling (21)

drivetrain (26)

electrical (75)

engine (65)

exhaust (24)

hvac (23)

interior (24)

maintenance (31)

steering (23)

suspension (43)

transmission (42)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →