Free API

2001 INFINITI G20

2.0L I4FWDAUTOMATICgas
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this G20
5-Year Cost of Ownership
$24,631 maintenance + known platform issues
~$4,926/yr · 410¢/mile equivalent · $7,069 maintenance + $3,862 expected platform issues

Common Problems & Known Issues

The 2001 G20 uses Nissan's SR20DE engine—generally reliable but prone to specific catastrophic failures when oil maintenance lapses. The platform shares components with the Sentra SE-R, making parts available but certain mechanical issues are expensive when they occur.

Catastrophic Engine Bearing Failure (Oil Starvation)

Occasional · high severity
Typical onset: 100,000-150,000 mi
Symptoms: Knocking or rattling from lower engine, Loss of oil pressure, Metal shavings in oil, Sudden engine seizure in severe cases
Fix: SR20DE engines suffer rod and main bearing failure when oil change intervals are extended or wrong oil weight used. Requires full engine rebuild or short block replacement. 18-24 hours labor for short block R&R including timing chain, water pump, all gaskets, and fluids.
Estimated cost: $3,500-5,500

Head Gasket Failure with Overheating

Occasional · high severity
Typical onset: 120,000-180,000 mi
Symptoms: Coolant loss with no visible leaks, White smoke from exhaust, Overheating under load, Milky oil on dipstick or cap
Fix: Multi-layer steel head gaskets fail, often after cooling system neglect. Head removal, resurfacing, new gasket set, timing chain components, and coolant flush required. 12-16 hours labor. If heads are warped beyond .003 inch, replacement needed.
Estimated cost: $1,800-2,800

Transmission Oil Cooler Line Corrosion and Leaks

Common · medium severity
Typical onset: 80,000-140,000 mi
Symptoms: ATF pooling under vehicle, Transmission running hot, Burnt smell from transmission, Low fluid level on dipstick
Fix: Steel cooler lines rust through where they pass over subframe, especially in salt-belt states. Requires replacement of hard lines and often flex hoses. 3-4 hours labor including fluid refill and leak check.
Estimated cost: $400-700

Transmission Mount Failure

Common · medium severity
Typical onset: 70,000-120,000 mi
Symptoms: Clunking when shifting from Park to Drive, Excessive engine movement visible from engine bay, Vibration at idle in Drive, Harsh engagement into gear
Fix: Front and rear transmission mounts deteriorate, causing powertrain movement. Front mount is particularly prone to tearing. Replacement requires supporting engine/trans, 2-3 hours labor for both mounts.
Estimated cost: $350-550

Distributor O-Ring Oil Leak

Common · low severity
Typical onset: 60,000-100,000 mi
Symptoms: Oil seeping around distributor base, Oil on spark plug wires, Occasional misfire when wet, Oil smell from engine bay
Fix: O-ring at distributor base hardens and leaks oil onto back of engine. Remove distributor, replace o-ring, reset timing. 1.5-2 hours labor. Preventive replacement recommended during timing chain service.
Estimated cost: $150-280

Fuel Filter Clogging (Internal Tank Filter)

Occasional · medium severity
Symptoms: Hesitation under acceleration, Rough idle, Hard starting when warm, Stalling after extended highway driving
Fix: In-tank fuel filter sock clogs from sediment, especially if tank has rust. Requires fuel pump assembly removal. Often discovered only after external filter replacement doesn't solve symptoms. 2-3 hours labor.
Estimated cost: $350-600

Timing Chain Tensioner and Guide Wear

Occasional · high severity
Typical onset: 150,000-200,000 mi
Symptoms: Rattling noise on cold start for first 3-5 seconds, Metallic noise from timing cover, Check engine light with cam/crank correlation codes, Rough running
Fix: Upper timing chain guide wears, and tensioner may lose pressure. If chain jumps timing, bent valves result. Timing chain set, tensioner, guides, water pump replacement recommended. 8-10 hours labor.
Estimated cost: $1,200-1,800
Owner tips
  • Use 5W-30 synthetic oil and change every 5,000 miles maximum—the SR20DE is unforgiving with oil maintenance
  • Flush coolant every 30,000 miles and replace thermostat preventively at 100k to avoid head gasket failure
  • Inspect transmission cooler lines annually in rust-belt regions; coat with rust inhibitor if surface rust appears
  • Replace timing chain components at 150,000 miles as preventive maintenance—far cheaper than engine rebuild
  • When buying used, pull dipstick and oil cap: any sludge buildup is a deal-breaker
Solid platform if maintenance history is documented, but oil neglect turns these into grenade motors—budget $2k-3k reserve for potential engine work on high-mileage examples.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 2001 Infiniti G20

494 jobs across 17 categories

body (31)

brakes (41)

drivetrain (24)

electrical (74)

engine (65)

exhaust (22)

hvac (23)

interior (24)

maintenance (31)

steering (19)

suspension (42)

transmission (42)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →