C0111moderate severityChassis
Brake Apply Circuit Low
on 2014 Jeep Cherokee 2.4L I4 · 4WD
What this code means
Low signal in the brake apply circuit indicates the module does not see brake application.
Symptoms
- Cruise control inoperative
- Shift interlock stuck
- Brake lights may not illuminate
- ABS light on
Common causes
- Brake switch stuck open
- Wiring short to ground
- Brake pedal not contacting switch
- Switch plunger broken
Diagnostic steps
- Check if brake lights illuminate when pedal pressed
- Test switch continuity
- Inspect switch mounting and pedal contact
- Check wiring for shorts to ground
Repair notes
Adjust or replace brake light switch. Check pedal bumper pad.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0025
LF Wheel Speed Sensor Circuit Intermittent