P0102moderate severityPowertrain
Mass Air Flow (MAF) Circuit Low Input
on 2014 Jeep Cherokee 2.4L I4 · 4WD
What this code means
The MAF sensor signal voltage is lower than the minimum expected value.
Symptoms
- Check Engine Light
- Loss of power
- Rich fuel condition
- Black smoke
Common causes
- Faulty MAF sensor
- Short in signal wire
- Disconnected sensor
- Contaminated sensor element
Diagnostic steps
- Check MAF sensor connector
- Test signal voltage
- Inspect wiring for shorts to ground
- Test sensor output
Repair notes
Replace MAF sensor or repair wiring.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1