C0501moderate severityChassis
Transfer Case Control Module Communication
on 2014 Jeep Cherokee 3.2L V6 · AWD
What this code means
Loss of communication between the transfer case module and other vehicle systems.
Symptoms
- 4WD light flashing
- Service 4WD warning
- Cannot select drive modes
- Transmission may default to limp mode
Common causes
- CAN bus wiring fault to module
- Module connector disconnected
- Module power loss
- CAN bus termination issue
Diagnostic steps
- Check CAN wiring to transfer case module
- Inspect module connector
- Verify power and ground at module
- Look for U-codes related to transfer case
- Check CAN bus resistance
Repair notes
Repair CAN wiring or connector. Replace module if communication chip failed.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0025
LF Wheel Speed Sensor Circuit Intermittent